FA-50 KAI Golden Eagle - Academy - No. 12519 - bashing of
![Album image #1 Album image #1](/albums/img/5/1/4/1144514-39693-52-720.jpg)
belly sectrion as starting parts of the T-50 kit
![Album image #2 Album image #2](/albums/img/5/0/2/1144502-39693-99-720.jpg)
"dry-fit" after cutting the belly section (well; this is a snap-tite ...)
![Album image #3 Album image #3](/albums/img/5/0/1/1144501-39693-98-720.jpg)
the cut away section of the original part below and the fitted Hasegawa wheel-bay already clued on top
![Album image #4 Album image #4](/albums/img/5/0/3/1144503-39693-56-720.jpg)
same from the other side
![Album image #5 Album image #5](/albums/img/5/0/4/1144504-39693-86-720.jpg)
close up of assembly; Hasegawa wheel bay basically is a good fit. wheel hatch has to be shortened for about 1mm
![Album image #6 Album image #6](/albums/img/5/0/5/1144505-39693-75-720.jpg)
close up again from the other side
![Album image #7 Album image #7](/albums/img/5/0/6/1144506-39693-91-720.jpg)
"dry fit" of the modified section
![Album image #8 Album image #8](/albums/img/5/0/7/1144507-39693-12-720.jpg)
close up without intake nozzles attached
![Album image #9 Album image #9](/albums/img/5/0/8/1144508-39693-31-720.jpg)
![Album image #10 Album image #10](/albums/img/5/0/9/1144509-39693-22-720.jpg)
![Album image #11 Album image #11](/albums/img/5/1/1/1144511-39693-67-720.jpg)
Gray parts from Hasegawa (wheel bays pre-primed in white);
Front wheel section is from Hasegawa too - turned 180°
Front wheel section is from Hasegawa too - turned 180°
![Album image #12 Album image #12](/albums/img/5/1/0/1144510-39693-35-720.jpg)
well only at the end of the project figured out that the phylons should be placed further towards the wingtips for sufficient space for ordnance...
![Album image #13 Album image #13](/albums/img/5/1/2/1144512-39693-71-720.jpg)
![Album image #14 Album image #14](/albums/img/5/1/3/1144513-39693-23-720.jpg)
コメント
4 9 January 2022, 11:54
![](/profiles/img/27826-126-s.jpg)
Nork, thanks for showing us a solution to the problem with no wheel bays in this kit.
Good job! 👍
9 January 2022, 18:59
Album info
"what-if" the TA-50 would have won the T-X-Programm
Kitbash with Hasegawa F-16CJ (Block 50) Fighting Falcon (Hasegawa 00448, 1:72) for conversion to FA-50. Used parts from Hasegawa:
- tail fin
- wheelbay and undercarriage
- pylons
Academy kit in white; Hasegawa parts in gray
unfortunatelly I did not capture all steps - and those I did; only with the camera on my cellular...