News Feed

Steven Van Dyck
A bad day at the wharf, the deck markings of Essex were botched because of a bad primer on the PE parts and bleeding of the white paint under the tape. The chipped PE I can handle, but I don't know if the wood can be cleaned up to have the same blue as it was doped in. I'll try to overpaint with the Lifecolor Deck Blue and then again some light sand brown for the weathering. You also see a correction that was needed for the deck edge elevator floor. This is extended too far out in the models if you want the elevator in the down position. I could saw it out in Essex, but in Hancock the hull apparently was not flush with the wood deck safety railing PE part. I just added a new front for the elevator. I also made a new better fitting third elevator edge for Essex, you see the earlier attempt at the top and the badly etched Pontos one on the right. Now I'll go and repaint that deck.

Ben M
Good luck on the fixes!

Ben M
The whitewash weathering is superb.