GB Finlandia Me109G-6
The wings are in place. Very good fit, almost no putty used.
I'll need to make some detail here since it's just an open whole.
Here is what I've done, just a small metal screen.
Canopy had a coat of Future and set aside to dry overnight. Than the masking was done using Tamiya tape.
Some scratch built made to improve the sand filter.
Pitot tube and fuselage antenna added
Pitot tube and fuselage antenna added
Pre-shading with XF01
Underside painting: 8*XF23+1*XF02
Top side camo: Olive green: 1*XF21+1*XF22+1*XF65
Opmerkingen
1 25 November 2014, 00:31
Lutz Schramm
Your first steps already look very good. I would rather have taken the AZmodel kit ( azmodel.cz/product_i..&products_id=682 ), he has turned out in my opinion better - bu, it´s your turn 😉.
One Note - the rack for the auxiliary fuel tank was installed offset 40 mm to the left of the aircraft centerline.
Your first steps already look very good. I would rather have taken the AZmodel kit ( azmodel.cz/product_i..&products_id=682 ), he has turned out in my opinion better - bu, it´s your turn 😉.
One Note - the rack for the auxiliary fuel tank was installed offset 40 mm to the left of the aircraft centerline.
25 November 2014, 14:07
Paulo Castro
Hi Lutz
I know the AZ model is better, but I had this in stash and didn't want to waste. You're right about the auxiliary tank rack, but it's done now.
Cheers!
Hi Lutz
I know the AZ model is better, but I had this in stash and didn't want to waste. You're right about the auxiliary tank rack, but it's done now.
Cheers!
26 November 2014, 00:14
Album info
Work in progress