Monogram F7F-3 TIGERCAT 001
At this point I decided to start careful dissasembly for a complete do over.
The Starfighter resin set into the Wheel wells, so far I have found that the resin set is not completely accurate, you need to do some creative cutting and re-positioning to get it to fit right with the landing gear
Had to split the nose to insert Forward Wheel Well
Since the nose was split I decided to re-work the cockpit, added a coaming from styrene strip
Drilled a hole on the top of the nose to add lead shot.
Adding CA to lock it in.
New Instrument panel, need to find a decal for that.
Engine Housing / Main Wheel Wells before picture
Engine housing and Main Wheel Wells, need to be gutted
Opmerkingen
20 July 2018, 16:49