P-30 Radar
cabin, basic construction
cabin, basic construction
Start of the carrying frame for the upper antenna. Just a test to see whether it can be soldered completely...
First part survived... ready for clean-up... still a lot to do for the baseframe for the first antenna
To obtain the double curvature from the disk I'll try to make it in styrene or PE
some details
Opmerkingen
8 March 2019, 08:19
Bart Goesaert
Made a start with this one... trying to replace the PE by soldered parts... 2 sides done, 2 sides to go...
Made a start with this one... trying to replace the PE by soldered parts... 2 sides done, 2 sides to go...
8 March 2019, 08:30
Bart Goesaert
sst... I use it for cutting my T-bones IRL... but must admit, to place the last parts it became a challenge of where to place the soldering iron
sst... I use it for cutting my T-bones IRL... but must admit, to place the last parts it became a challenge of where to place the soldering iron
13 March 2019, 10:29
Bart Goesaert
To try to obtain the double curvature of the original disk, I'm trying to make my own design. Anybody who some good references for self made PE or lasering/milling in styrene, feel free to share.. (preferably europe)
To try to obtain the double curvature of the original disk, I'm trying to make my own design. Anybody who some good references for self made PE or lasering/milling in styrene, feel free to share.. (preferably europe)
20 March 2019, 13:17