Academy Graf Spee
![Album image #1 Album image #1](/albums/img/9/8/2/686982-46003-65-720.jpg)
![Album image #2 Album image #2](/albums/img/9/8/5/686985-46003-11-720.jpg)
![Album image #3 Album image #3](/albums/img/9/8/3/686983-46003-42-720.jpg)
![Album image #4 Album image #4](/albums/img/9/8/4/686984-46003-11-720.jpg)
![Album image #5 Album image #5](/albums/img/0/1/0/685010-46003-55-720.jpg)
Nearly Done
![Album image #6 Album image #6](/albums/img/4/7/2/671472-46003-98-720.jpg)
Added the Fake-wave and a bit of rust 😄
![Album image #7 Album image #7](/albums/img/4/7/4/671474-46003-82-720.jpg)
![Album image #8 Album image #8](/albums/img/4/7/3/671473-46003-54-720.jpg)
![Album image #9 Album image #9](/albums/img/1/0/0/660100-46003-94-720.jpg)
![Album image #10 Album image #10](/albums/img/1/0/1/660101-46003-94-720.jpg)
![Album image #11 Album image #11](/albums/img/1/0/2/660102-46003-12-720.jpg)
![Album image #12 Album image #12](/albums/img/1/0/3/660103-46003-56-720.jpg)
![Album image #13 Album image #13](/albums/img/1/0/4/660104-46003-68-720.jpg)
![Album image #14 Album image #14](/albums/img/1/4/5/660145-46003-78-720.jpg)
Opmerkingen
6 October 2019, 14:15
![](/profiles/img/28845-385-s.jpg)
You can probably knock down some of the paint edges along the masked water line, very carefully with fine sanding paper, before adding a gloss coat, otherwise, maybe leave it, as sanding paint will require adding a gloss coat to look ok again. There is also a danger of sanding through the paint if you also sand the flat areas with thinner layer of paint, which is ofc undesirable.
6 October 2019, 14:41
![](/profiles/img/28909-839-s.png)
Mmm. I've got this one as well, somewhere on my shelf of half finished. Perhaps I can find some inspiration here?
6 October 2019, 15:57
![](/profiles/img/46003-513-s.jpg)
Thats a good idea, i think i will give it a try 😄
You think 1500er Sandpaper can do the Job?
I added my inspiration for my one in this Album😉
6 October 2019, 16:33
![](/profiles/img/28845-385-s.jpg)
I am not sure. Also, best add some masking tape around the hull, so you don't scratch the paint elsewhere. As I commented before, I am assuming that you will add a gloss coat, else, probably not a good idea, sanding plain paint tend to look, bad.
6 October 2019, 16:48
![](/profiles/img/46003-513-s.jpg)
Later i saw these Edges comes from the Hull Part, maybe the mark to cut the Hull for a waterline model.
10 November 2019, 16:10