Panda M-ATV
![Album image #1 Album image #1](/albums/img/3/5/9/674359-58861-26-720.jpg)
The Blast resin radios on the Voyager PE radio racks.
![Album image #2 Album image #2](/albums/img/3/6/0/674360-58861-34-720.jpg)
I've been adding the power, audio and antenna cables to the radios. It brings back memories of change of command inventories from years gone by.
![Album image #3 Album image #3](/albums/img/3/6/1/674361-58861-60-720.jpg)
The weapon station is PE. It helps to drill holes and glue plastic pins at the bolt locations to hold the parts in the correct place while the glue sets.
![Album image #4 Album image #4](/albums/img/3/6/2/674362-58861-18-720.jpg)
I put in 3 of 4 sides for the ballistic glass. I'll add the last side after the paining is completed.
![Album image #5 Album image #5](/albums/img/3/6/3/674363-58861-55-720.jpg)
The framework on the back of the vehicle is from the voyager PE set. The PE set includes the bolt heads in various sizes that need to be glued on.
![Album image #6 Album image #6](/albums/img/3/6/4/674364-58861-42-720.jpg)
I had to take a break from this build for a couple months. The combination of PE and CA glue was too much.
![Album image #7 Album image #7](/albums/img/0/0/3/675003-58861-78-720.jpg)
Panda does not include the VIC-3 system so I'll have to make that on my own. Change of plans. I found a 3D printed set from Shapeways for the Vic-3 and handsets.
![Album image #8 Album image #8](/albums/img/8/3/5/677835-58861-51-720.jpg)
Voyager provided the resin mirrors but you have to make the mount. I used Albion Alloys NST05 tubing.
![Album image #9 Album image #9](/albums/img/8/3/6/677836-58861-15-720.jpg)
Voyager PE and brass barrel helped out the .50cal.
![Album image #10 Album image #10](/albums/img/8/3/7/677837-58861-86-720.jpg)
The directions were incorrect for the seatbelts. I cut off the buckle and used masking tape for the belts. I need to do some weathering on the seats before they go in the vehicle.
![Album image #11 Album image #11](/albums/img/8/3/8/677838-58861-84-720.jpg)
I'll dirty up the inside before I put the windows in.
Opmerkingen
1 17 November 2019, 20:31