AH-1W
1July 31, 2020took a false start
2July 31, 2020
3July 31, 2020
4July 31, 2020resin from the engine set and the resin nose that came with the decals
5July 31, 2020allready cleaned parts
6July 31, 2020dryfit of the main resin parts
7July 31, 2020dryfit of the main resin parts
8July 31, 2020dryfit of the main resin parts
9July 31, 2020dryfit of the main resin parts
10September 12, 2020Start of the nosejob, easy part, remove the original part
11September 12, 2020then dry-fit the replacement, so far so good
12September 12, 2020but when checking with the glass parts it becomes another story... the angle is completely off. Need to think hoh to cope with this...
13September 12, 2020al lot of CA to fill the seams. Hope it will work well, because the plastic is terribly soft
14September 12, 2020al lot of CA to fill the seams. Hope it will work well, because the plastic is terribly soft
15September 12, 2020and scraped and sanded for the first time (I've removed some details with a knife to avoid damaging them, they will be reglued afterwards), ready to check the result with paint... Fingers crossed
16September 12, 2020and sanded for the first time, ready to check the result with paint... Fingers crossed
17September 12, 2020Bottom hull needed a lot of TLC too
Opmerkingen
17 October 2024, 16:35 -
