A-Models always challenging and rewarding ;)
Unfortunately the original build album has been deleted, so here are some new ones of the completed results.
After-market machine gun takes prominent position ahead of the propeller.
The pair of curved m/g supports are of bent copper wire, as the kit part was too badly moulded to be useable.
Every single wing strut had to be very carefully removed from the sprue and be cleaned up.
Opmerkingen
13 10 June 2023, 19:08
Bruce Huxtable
Welcome, both! I didn't quite get the gap between the propeller and the gunner's pod even. It's too close at the bottom... Not sure how I managed that....
Welcome, both! I didn't quite get the gap between the propeller and the gunner's pod even. It's too close at the bottom... Not sure how I managed that....
11 June 2023, 06:32