Nyhetsstrøm
pinta
eier nå
eier nå
Ox Towing a Me 163B w/2 Luftwaffe Ground Crew
CMK (Czech Master Kits) 1:72
F72346 2019 New tool Flertema (2)12 August, 11:56
bossy122
la til et nytt fotoalbum
la til et nytt fotoalbum
4 bilder
Peugeot 206 2000 Rally San Remo Panizzi1:24
Tried to paint the knobs n such with my less than stellar eyesight. ....could be worse.
Prosjekt: Peugeot 206 2000 Rally San Remo Panizzi
9 5 July, 20:08
Martin Oostrom
Can't you strip the sprues as a whole of the paint? Dip them in a bath of paint stripper? Might be a whole lot easier than sanding each piece
Can't you strip the sprues as a whole of the paint? Dip them in a bath of paint stripper? Might be a whole lot easier than sanding each piece
9 July, 06:15
bossy122
Most of the pieces are under carriage, so they're not that visible......but I stay awake at night knowing there are seams and that they must be eliminated! I think I botched the body paint job and I hadn't noticed on its original project. I just went over the lint - think HAIR - with 600 to 2000 and that took care of it. Mostly, I just thought it was funny that whomever I bought this kit from had gone to that much trouble to paint pieces ON the sprues with a brush, only to be done over with a rattlecan OFF the sprues.
Most of the pieces are under carriage, so they're not that visible......but I stay awake at night knowing there are seams and that they must be eliminated! I think I botched the body paint job and I hadn't noticed on its original project. I just went over the lint - think HAIR - with 600 to 2000 and that took care of it. Mostly, I just thought it was funny that whomever I bought this kit from had gone to that much trouble to paint pieces ON the sprues with a brush, only to be done over with a rattlecan OFF the sprues.
9 July, 06:23
Martin Oostrom
I feel your pain. I'm currently sanding tanks on a truck. Tanks that will never be seen, yet I've spent a few hours already on them.
I feel your pain. I'm currently sanding tanks on a truck. Tanks that will never be seen, yet I've spent a few hours already on them.
9 July, 06:25
bossy122
The TS4 German Grey isn't nearly dark enough for the dash. Or, the actual color of the dash should be black, but the instructions called out for German Grey......I dunno, Tamiya.
The TS4 German Grey isn't nearly dark enough for the dash. Or, the actual color of the dash should be black, but the instructions called out for German Grey......I dunno, Tamiya.
12 August, 06:51
Irineu Junior
la til et nytt fotoalbum
la til et nytt fotoalbum
28 21 December 2023, 23:10
Irineu Junior
Thanks Michael! I've always wanted to build a rally car like this!
I'll try to keep that album updated.
Thanks Michael! I've always wanted to build a rally car like this!
I'll try to keep that album updated.
22 December 2023, 19:16
Irineu Junior
Chassis painted with spray. I'll take the paint off the can and use in airbrush.
It will be easier to control the flow, mainly on the body.
Chassis painted with spray. I'll take the paint off the can and use in airbrush.
It will be easier to control the flow, mainly on the body.
23 February, 19:37
bossy122
Having done one of these recently, I will give you a heads up that the decals canbe a tad brittle, especially the big ones going across the doors. LOTS of softener needed. PS: beautiful seal point.
Having done one of these recently, I will give you a heads up that the decals canbe a tad brittle, especially the big ones going across the doors. LOTS of softener needed. PS: beautiful seal point.
24 February, 18:44
Irineu Junior
Thanks, folks! I'll try to update frequently.
Good tip, @bossy122, thank you!
I messed up a lot with the panel line scraper, had to fix with CA and sandpaper…
Thanks, folks! I'll try to update frequently.
Good tip, @bossy122, thank you!
I messed up a lot with the panel line scraper, had to fix with CA and sandpaper…
24 February, 20:12
Irineu Junior
Body painted, with airbrush and decanted TS-50. Next steps: decals and clear coat.
Body painted, with airbrush and decanted TS-50. Next steps: decals and clear coat.
2 June, 21:39
Jorge Ferreira
Well what can I say. Was it beginners luck or a skillfull modeller ? Those decals look great. I`ve build 4 and the decals were a nightmare. Congratulations. 😊👌
Well what can I say. Was it beginners luck or a skillfull modeller ? Those decals look great. I`ve build 4 and the decals were a nightmare. Congratulations. 😊👌
11 August, 20:16
Irineu Junior
Thank you Jorge and Stéphane! I've been building it at a slow pace, getting a lot of help from forums and videos.
Thank you Jorge and Stéphane! I've been building it at a slow pace, getting a lot of help from forums and videos.
12 August, 09:37
Ercan Karakaş
eier nå
eier nå
Boeing B-17 Flying Fortress Machine Gun Barrels Set Includes 13 Barrels, 13 Jackets & 4 Flash Hiders
Master 1:48
AM-48-138 2017 12 August, 11:52
Thomas Kolb
la til et nytt fotoalbum
la til et nytt fotoalbum
38 5 July, 07:59
Łukasz Gliński
Me 3, I have to see that! Still procrastinating mine 😄
Thomas, are you considering getting rid of the decal with my support perhaps? 😉
Me 3, I have to see that! Still procrastinating mine 😄
Thomas, are you considering getting rid of the decal with my support perhaps? 😉
26 July, 20:14
Thomas Kolb
Łukasz, I am not going to use the provided decal sheet, so if you want it, just PM me with your address and I can post it.
Łukasz, I am not going to use the provided decal sheet, so if you want it, just PM me with your address and I can post it.
26 July, 21:48
Thomas Kolb
(And for everybody else with knowledge about the different versions of the Yak-12, yes, I am aware of the differences between the A-version in the kit and the R-version used by the Hungarian People's Army. But since I am not able to scratch build the entire wing and empennage structure, let's just call it artistic license.)
(And for everybody else with knowledge about the different versions of the Yak-12, yes, I am aware of the differences between the A-version in the kit and the R-version used by the Hungarian People's Army. But since I am not able to scratch build the entire wing and empennage structure, let's just call it artistic license.)
28 July, 11:08
Thomas Kolb
Thank you very much, dear gentlemen for your attention and encouraging words!
Thank you very much, dear gentlemen for your attention and encouraging words!
31 July, 14:48
Bruce Huxtable
Admiring your skills, and learning from your problem-solving, Thomas. Transforming an A-Model kit adds to the challenges 😉
Admiring your skills, and learning from your problem-solving, Thomas. Transforming an A-Model kit adds to the challenges 😉
4 August, 15:36
Thomas Kolb
Thank you Michael, Nicolas & Bruce for your interest and compliments! This kit is actually not quite as bad as some other Amodel kits I have built - the designers have created some pretty nifty solutions here! If anything, it is a bit unforgiving - make one small mistake and you can be sure that it will keep coming back to kick you.
Thank you Michael, Nicolas & Bruce for your interest and compliments! This kit is actually not quite as bad as some other Amodel kits I have built - the designers have created some pretty nifty solutions here! If anything, it is a bit unforgiving - make one small mistake and you can be sure that it will keep coming back to kick you.
5 August, 20:35
Bernhard Pethe
Wunderbarer Modellbau. Ich hab das Modell auch noch liegen und genauso wollte ich es auch machen. Mal sehen, wenn ich groß bin. 😉
Wunderbarer Modellbau. Ich hab das Modell auch noch liegen und genauso wollte ich es auch machen. Mal sehen, wenn ich groß bin. 😉
9 August, 16:24
Thomas Kolb
Bernhard, danke schön! 🙂 Ja, es ist ein ziemlich kniffliges Modell, aber es macht großen Spaß, es zu bauen!
Bernhard, danke schön! 🙂 Ja, es ist ein ziemlich kniffliges Modell, aber es macht großen Spaß, es zu bauen!
9 August, 17:17
Nicolas
Yes Thomas, I don't think you get any easy builds from Amodel. But with some work you get a nice and rare model. I realy like your progress. 👍
Yes Thomas, I don't think you get any easy builds from Amodel. But with some work you get a nice and rare model. I realy like your progress. 👍
9 August, 19:22
Thomas Kolb
Bruce, Lukasz, Cuajete, Nicolas, thank you! Yes, Amodel is actually cool in that they take a chance to make models outside the ordinary. Who else would design a model kit of a strange and ugly little high-winged Soviet aircraft instead of another Stuka, Tomcat or a Spitfire?
Bruce, Lukasz, Cuajete, Nicolas, thank you! Yes, Amodel is actually cool in that they take a chance to make models outside the ordinary. Who else would design a model kit of a strange and ugly little high-winged Soviet aircraft instead of another Stuka, Tomcat or a Spitfire?
10 August, 08:01
Thomas Kolb
Roland thank you mate! Cuajete, yes, this is the best gloss coat I have ever tried. It levels out to an absolute mirror shine (at least if it is applied to a perfectly smooth paint layer). This model ended up with a bit of orange peel effect at some places, so it is not absolutely perfect, but I can get away with it.
Roland thank you mate! Cuajete, yes, this is the best gloss coat I have ever tried. It levels out to an absolute mirror shine (at least if it is applied to a perfectly smooth paint layer). This model ended up with a bit of orange peel effect at some places, so it is not absolutely perfect, but I can get away with it.
10 August, 18:54
Thomas Kolb
Hereby I declare the project finished! Quite a fast progress for me, only three weeks from start to finish. It may not be the best model I have ever built - there are too many silly or clumsy mistakes here and there - but it was great fun! More photos will come!
Hereby I declare the project finished! Quite a fast progress for me, only three weeks from start to finish. It may not be the best model I have ever built - there are too many silly or clumsy mistakes here and there - but it was great fun! More photos will come!
12 August, 07:50
Łukasz Gliński
That escalated quickly and nicely 👍
Where did you get the snow from in August? I know it's up north, but still... 😉
That escalated quickly and nicely 👍
Where did you get the snow from in August? I know it's up north, but still... 😉
12 August, 08:13
CasModeler
la til et nytt fotoalbum
la til et nytt fotoalbum
26 28 April, 09:37
Ricard Gomicia Calatayud
great job! I don't know if I'd be abme to dirt it after finishing it hahaha
great job! I don't know if I'd be abme to dirt it after finishing it hahaha
3 July, 21:45
CasModeler
@Ricard
Of course you can do wash after finishing. Just use enamel/acrylics paints and pigment(pulver).
@Ricard
Of course you can do wash after finishing. Just use enamel/acrylics paints and pigment(pulver).
4 July, 19:30
JojoTheWiseWolf
ønsker
ønsker
B-239 Buffalo & Messerschmitt Bf109G-6 `Finnish Air Force`
Hasegawa 1:72
02279 2018 Byggesett Flertema (2)12 August, 11:45
Eugene Dyatlov
ønsker
ønsker
Back to the Future
Time machine from Back to the Future part IAoshima 1:24
064368 (BT-01) 2024 New tool 12 August, 11:44
/no/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=no
35
35
/no/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo