Nyhetsstrøm
Cristopher Holcomb
la til et nytt fotoalbum
la til et nytt fotoalbum
34 bilder
P 51B MustangNy: 16 September, 15:07 1:48
Tamiya kit has a very good interior, but is missing the plywood floor so I made it in scratch in plasticard
Prosjekt: P 51B Mustang " Shangri-la"
5 15 July, 16:06
Christoph Kunz
Nice build.
And it seems like it's going to be an interessting painting. 👍
Nice build.
And it seems like it's going to be an interessting painting. 👍
12 September, 14:58
Fabio
ønsker
ønsker
US M4 Sherman T-54E1 Workable Track Link w/ Duckbill Track Extenders
Gecko Models 1:35
35GM0094 2024 New tool 16 September, 15:04
Stephane
eier nå
eier nå
Tail rotor for СH-53E Super Stallion/MH-53E Sea Dragon
ResKit 1:48
RSU48-0037 16 September, 15:03
Stephane
eier nå
eier nå
Rotor CH-53 Super Stallion/MH-53E Sea Dragon (7 blades, 3 engines) for Academy
ResKit 1:48
RSU48-0021 16 September, 15:03
Giacomo
fullførte
fullførte
TF-104G, F-104D, F-104DJ Starfighter EXPERT kabuki masks for Hasegawa
New Ware 1:48
NWAM0248 2017 New tool 16 September, 15:03
Transall NG
eier nå
eier nå
Avions contre U-Boote.
Le Fana de l'Aviation Hors Série Nr. 36
FRANKS, Norman, P. Facon, M. Bénichou, X. Méa...
2007 16 September, 15:02
Greg Baker
la til et nytt fotoalbum
la til et nytt fotoalbum
20 bilder
Cigars of the Pharaoh (Hawker Demon)Ny: 16 September, 14:15 1:72
Prosjekt: Cigars of the Pharaoh (Hawker Demon)
36 18 April, 05:15
Greg Baker
This one is likely to be a quick little build. It's basically the companion piece to the Puss Moth, so I felt like I couldn't really build one without the other. Erik is right though, the kit is of an impressive vintage. It is indeed a few years older than I am, and has the flash to prove it. 🙂
Anyway, thanks for joining, there's plenty of seats available, so no shoving. 😉
This one is likely to be a quick little build. It's basically the companion piece to the Puss Moth, so I felt like I couldn't really build one without the other. Erik is right though, the kit is of an impressive vintage. It is indeed a few years older than I am, and has the flash to prove it. 🙂
Anyway, thanks for joining, there's plenty of seats available, so no shoving. 😉
18 April, 14:01
Greg Baker
You say that now... but wait till you see how much putty and sanding is required~
You say that now... but wait till you see how much putty and sanding is required~
6 May, 19:05
Greg Baker
Well, it's supposed to be a Hawker Hart apparently... but the Hawker Demon is close enough... I mean, it's not like it's a Spitfire. 😉
Well, it's supposed to be a Hawker Hart apparently... but the Hawker Demon is close enough... I mean, it's not like it's a Spitfire. 😉
6 May, 23:10
Alex K
Good enough for me - I'm arguably one of the least rivet-counting persons in here... just asking/checking... 😉
Good enough for me - I'm arguably one of the least rivet-counting persons in here... just asking/checking... 😉
6 May, 23:25
Matthew A
And only a masochist with ADHD would consider trying to convert it back to a Hart like the original 1957 tool... 🤪
And only a masochist with ADHD would consider trying to convert it back to a Hart like the original 1957 tool... 🤪
7 May, 16:18
Greg Baker
What did you call me? 😉
I mean, besides the dip between the two cockpits... are there any other differences? They look quite similar to me...
What did you call me? 😉
I mean, besides the dip between the two cockpits... are there any other differences? They look quite similar to me...
7 May, 17:57
Alex K
Well, the "dip between the two cockpits" is the main difference I was referring to above... Plus, you'll have to skip the Demon's long exhausts, I guess...
Well, the "dip between the two cockpits" is the main difference I was referring to above... Plus, you'll have to skip the Demon's long exhausts, I guess...
7 May, 18:25
Greg Baker
Not exactly sure what picture to take to update my progress… I'm working on bits of everything all at once!
Not exactly sure what picture to take to update my progress… I'm working on bits of everything all at once!
10 May, 05:52
Matthew A
The main difference between a Demon and a Hart is the exhausts, the turret and the starboard machine gun. Will send a PM
The main difference between a Demon and a Hart is the exhausts, the turret and the starboard machine gun. Will send a PM
16 May, 16:53
Alex K
IF however (regardless of how a real Hart should be) what is shown in the comic ("That's what I call" etc frame) is indeed a starboard mg (please correct me if I'm wrong...) then starting with a Demon kit was perhaps indeed a better idea than starting with a Hart kit.... IF this is the case... then you'll only have to deal with the rear seat/turret thing and the free (ala Fury) exhausts, no?
IF however (regardless of how a real Hart should be) what is shown in the comic ("That's what I call" etc frame) is indeed a starboard mg (please correct me if I'm wrong...) then starting with a Demon kit was perhaps indeed a better idea than starting with a Hart kit.... IF this is the case... then you'll only have to deal with the rear seat/turret thing and the free (ala Fury) exhausts, no?
16 May, 19:43
Greg Baker
Yeah. I think so. Matthew provided some detailed comparison images but after looking at them and at the main page from the album... it seems to be a little bit of both...
Yeah. I think so. Matthew provided some detailed comparison images but after looking at them and at the main page from the album... it seems to be a little bit of both...
16 May, 22:09
Matthew A
In Tintin in the Land of the Black Gold it could be a Hawker Hardy
i.imgur.com/57c2RcA.jpeg
In Tintin in the Land of the Black Gold it could be a Hawker Hardy
i.imgur.com/57c2RcA.jpeg
23 May, 21:51
Greg Baker
A couple of updates. The supports next to the fuselage were so weak that 3/4 of them snapped even before I got them off the sprue. So instead I just used some bent wire. The holes they are meant to slot into were gaping caverns as well, so a fair amount of putty was needed to make it at least slightly better. Now I'm left with a decision to make. The Hawker Demon has two large exhaust tubes that run from the engine down the sides. They're not present in the Tintin album (which most closely resembles a Hawker Heart I believe). So... do I leave the two side holes and the large trenches on either side of the engine cowling, or do I just shrug my shoulders and use the parts that came in the box?
The Blue Rider decals went on easily enough. They're a bit shiny, but I think I can deal with that.
A couple of updates. The supports next to the fuselage were so weak that 3/4 of them snapped even before I got them off the sprue. So instead I just used some bent wire. The holes they are meant to slot into were gaping caverns as well, so a fair amount of putty was needed to make it at least slightly better. Now I'm left with a decision to make. The Hawker Demon has two large exhaust tubes that run from the engine down the sides. They're not present in the Tintin album (which most closely resembles a Hawker Heart I believe). So... do I leave the two side holes and the large trenches on either side of the engine cowling, or do I just shrug my shoulders and use the parts that came in the box?
The Blue Rider decals went on easily enough. They're a bit shiny, but I think I can deal with that.
11 September, 15:38
Greg Baker
Thanks Matthew. I'm quite pleased with how the colouring came out too. A 2:1 ratio of Tamiya Buff (XF-57) and Khaki (XF-49) seems to have done the trick... or at least close enough for me.
Thanks Matthew. I'm quite pleased with how the colouring came out too. A 2:1 ratio of Tamiya Buff (XF-57) and Khaki (XF-49) seems to have done the trick... or at least close enough for me.
11 September, 15:58
Greg Baker
I just noticed the artwork has actual rigging on it, so it looks like I'm not quite as done as I thought. Besides that, only a few nice white fluffy clouds needed for the base.
I just noticed the artwork has actual rigging on it, so it looks like I'm not quite as done as I thought. Besides that, only a few nice white fluffy clouds needed for the base.
13 September, 13:50
karelsem
ønsker
ønsker
17 August 2023, 20:02
Scott Lyon
I have one for sale, £85 + postage? If your interested get back to me either way, i've offered to two others here, so first come first served. best regards Scott
I have one for sale, £85 + postage? If your interested get back to me either way, i've offered to two others here, so first come first served. best regards Scott
16 September, 15:01
Geoff Denyer
ønsker
ønsker
30 March, 01:12
Scott Lyon
I have one for sale, £85 + postage? If your interested get back to me either way, i've offered to two others here, so first come first served. best regards Scott
I have one for sale, £85 + postage? If your interested get back to me either way, i've offered to two others here, so first come first served. best regards Scott
16 September, 15:00
John Dolan
ønsker
ønsker
2 December 2022, 04:18
Scott Lyon
I have one for sale, £85 + postage? If your interested get back to me either way, i've offered to two others here, so first come first served. best regards Scott
I have one for sale, £85 + postage? If your interested get back to me either way, i've offered to two others here, so first come first served. best regards Scott
16 September, 14:59
nikfrost
la til et nytt fotoalbum
la til et nytt fotoalbum
11 14 August, 21:18
CaptGPF
I love you how had your daughter choose the color! I sense a scheme to draw her into the hobby? 😜
I love you how had your daughter choose the color! I sense a scheme to draw her into the hobby? 😜
24 August, 14:10
nikfrost
I didn't ask her, she spotted what I was doing and told me it needs to be pink! Can't disagree with that hahaha. She's quite handy with Alan the Airbrush already, I think I'll buy her some cheap 1:72 planes to have a go with on her own for starters.
I didn't ask her, she spotted what I was doing and told me it needs to be pink! Can't disagree with that hahaha. She's quite handy with Alan the Airbrush already, I think I'll buy her some cheap 1:72 planes to have a go with on her own for starters.
24 August, 14:15
CaptGPF
If she's already handy with the airbrush - you're already halfway into reeling her into the craft! Good luck with that - and looking forward to the final result for this build!
If she's already handy with the airbrush - you're already halfway into reeling her into the craft! Good luck with that - and looking forward to the final result for this build!
24 August, 14:36
/no/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=no
35
35
/no/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo