Work In Progress

Use silicon and vasellin to avoid glue penetrate to steering rod. 

make control pannels thinner. 

 

add width to cockpit walls 

 

add length to tail wing's rod to be held by poly-cap firmly. 

test fit the poly-cap 

add some texture to epoxy putty with rotling 

0.4mm masking tape worked. 

 

 

 

surface treatment done 

preparation for early type of beaver tail 

 

make a square hole where cooling fan is 

light wood sandwiched. 

after some work clean surface archieved. 

inactivate gun. 

sand off the patch on tails. 

improve the shape of cooling duct. 

there are still some gaps to fill. 

mesh added. gap between intake and body is manageable at thiis stage. 

represent some sensor in left intake. 

used tamiya gear for support when wings are open. 

check the balance to see amount of weight needed. 

broken arrow.. 

fixit 

polycap settled 

change the shape of beaver tail 

 

undercoat in black and whites 

this need lots of filling 

again.. 

 

Paint job done. 

although not completed yet, set on display for Yokohama modellers club joint exhibition on15th-16th Sept.