KV-1 heavy cast turret
![Album image #1 Album image #1](/albums/img/7/6/2/150762-11032-29-720.jpg)
general view
![Album image #2 Album image #2](/albums/img/7/6/3/150763-11032-69-720.jpg)
cutting/weld marks added
![Album image #3 Album image #3](/albums/img/7/6/4/150764-11032-79-720.jpg)
cutting/weld marks added
![Album image #4 Album image #4](/albums/img/7/6/5/150765-11032-45-720.jpg)
more cutting/weld marks added
![Album image #5 Album image #5](/albums/img/7/6/6/150766-11032-49-720.jpg)
more cutting/weld marks added
![Album image #6 Album image #6](/albums/img/7/6/7/150767-11032-84-720.jpg)
grille added
![Album image #7 Album image #7](/albums/img/7/4/5/151745-11032-57-720.jpg)
first soldered parts
Kommentarer
5 December 2014, 16:45
![](/profiles/img/18109-957-s.jpg)
I like those welding marks. Can you share how did you make them? I'm also working on a KV-1 right now.
13 February 2015, 22:33
![](/profiles/img/user-s.jpg)
thx, just took a look on your model, it's looking fine.
For the weldmarks, I used two methods:
- I cut small strips of styrene sheet and glue these on their place. With Tamiya ultra thin cement I soften them up and carve them with a knife. To soften the sharp edges, I apply some more cement afterwards to melt the edges.
- Same way as above, but instead of styrene strip I use different sections of streched sprue that are glued next to and above eachother. These are treated the same way, but give a less uniform surface...
The cutting marks are engraved with a sharp knive, by rapidly moving it on a right angle with the border of the plate. The number of passes with the knife define the degree of damage. Afterwards I also use thin cement to soften the sharp edges
14 February 2015, 01:31
Album info
This is a second hand kit, that had allready been begun by the owner. Weldmarks and cutting marks added, some parts are soldered to improve strength