P-30 Radar
![Album image #1 Album image #1](/albums/img/1/1/2/584112-11032-19-720.jpg)
cabin, basic construction
![Album image #2 Album image #2](/albums/img/1/1/3/584113-11032-42-720.jpg)
cabin, basic construction
![Album image #3 Album image #3](/albums/img/1/1/1/584111-11032-57-720.jpg)
Start of the carrying frame for the upper antenna. Just a test to see whether it can be soldered completely...
![Album image #4 Album image #4](/albums/img/9/6/3/585963-11032-34-720.jpg)
First part survived... ready for clean-up... still a lot to do for the baseframe for the first antenna
![Album image #5 Album image #5](/albums/img/6/1/9/588619-11032-51-720.jpg)
To obtain the double curvature from the disk I'll try to make it in styrene or PE
![Album image #6 Album image #6](/albums/img/6/2/0/588620-11032-27-720.jpg)
some details
Kommentarer
8 March 2019, 08:19
![](/profiles/img/user-s.jpg)
Made a start with this one... trying to replace the PE by soldered parts... 2 sides done, 2 sides to go...
8 March 2019, 08:30
![](/profiles/img/user-s.jpg)
sst... I use it for cutting my T-bones IRL... but must admit, to place the last parts it became a challenge of where to place the soldering iron
13 March 2019, 10:29
![](/profiles/img/user-s.jpg)
To try to obtain the double curvature of the original disk, I'm trying to make my own design. Anybody who some good references for self made PE or lasering/milling in styrene, feel free to share.. (preferably europe)
20 March 2019, 13:17