Kinetic F/A-18A+/B / CF-188 - Build
Kommentarer
35 18 April 2021, 10:30
![](/profiles/img/48987-587-s.jpg)
Nice subject! ?
Typical kinetic kit but its the best we've got for the legacy hornet?♂️. There are some workarounds to be found in forums, e.g. internal spacers/sidewalls for the rear part.
Watching!
8 May 2021, 17:32
![](/profiles/img/74389-420-s.jpg)
Also taking a seat, looks quite good so far, like the detail paintwork in the landing gear area as well as in the cockpit. 👍
18 June 2021, 22:09
![](/profiles/img/38375-466-s.jpg)
a bit of progress here, everything is now painted (even though i think i didn't hit the color tone very good, hopefully weathering improves that...) and there is one correction needed as the paint peeled in one spot.
18 August 2021, 10:11
![](/profiles/img/10306-948-s.jpg)
Oh 410 Cougars training squadron. Same one I want to build. Looking great!
15 October 2021, 07:58
![](/profiles/img/38375-466-s.jpg)
I like double-seaters, so that was the one to go with the kinetic kit 😉
15 October 2021, 09:56
![](/profiles/img/74389-420-s.jpg)
Great work Schnemat, really like the outcome so far! 👍
As to your question about the pod, I think it goes on the left side fuselage anchoring normally reserved for the air-to-air missiles - at least this is the case for the Rhino Hornet.
23 October 2021, 01:10
![](/profiles/img/48987-587-s.jpg)
Pic 32 shows you're already using the correct pod in the correct position 👍
(pic 31 shows the litening pods that preferably goes centerline position on most non-navy hornets - but also not used by RCAF)
a great looking hornet, I really like the typical streaks behind the slats, looking forward to the big rollout! 👍
23 October 2021, 13:00
![](/profiles/img/38375-466-s.jpg)
Thank you for all your nice comments! I hope the canopy is not going to ruin the whole model...
23 October 2021, 14:55