A-20G 1/48
That's how slowly things are progressing. The engine cover has been drilled out where the hot air outlets are located. The cover of the opening were milled out.
That's how slowly things are progressing. The engine cover has been drilled out where the hot air outlets are located. The cover of the opening were milled out.
Fit test of the engine. Behind the engine additional fastening bolts glued in so that the engine does not sink in the installed state during propeller assembly.
Finished propeller. Chipping with Vallejo Chipping Medium. Weathering is still to come.
Fit test. Pretty I think. What do you say?
Cockpit ready. Lifeboat inside. Made out of Fimo.
started to paint it. first pre shading then neutral grey
started to paint it. first pre shading then neutral grey
First time worked with masking putty
First time worked with masking putty
This moment when you see after two hours of masking after painting that everything has become perfect.... Priceless.... Bit proud. Hope you like it.
This moment when you see after two hours of masking after painting that everything has become perfect.... Priceless.... Bit proud. Hope you like it.
Almost ready to visit Pont du Hoc
Extra detail sheet from Foxbat
Putting decsls on before weathering
Putting decsls on before weathering
The stickers are too thin and the D-day stripes shone through. I cut stencils and brushed a white base. Here's how it works.
The stickers are too thin and the D-day stripes shone through. I cut stencils and brushed a white base. Here's how it works.
Weathering done
Weathering done
Weathering done
Weathering done
Weathering done
Weathering done
Tested AK Weathering Pencils
Tested AK Weathering Pencils
Kommentarer
22 3 November 2021, 12:57