Wiadomości
Mack McCrudden
posiada ten przedmiot
posiada ten przedmiot
Akagi Bridge W/Flight Deck and Nakajima B5N2 Kate Combo
Border Model 1:35
BSF-001 2023 Zestaw łączony Więcej niż jeden temat (2)28 September, 11:42
Sy Bar
dodał nowy album.
dodał nowy album.
19 zdjęć/zdjęcia
Bf110C-6Nowy: 28 September, 11:39 1:72
I’m amazed this went down, the secret was apply fit then use a hot hairdryer to heat shrink decals on!
Projekt: Bf-110C-6
23 18 September, 11:53
Sy Bar
Was going to do the Battle of Britain version of this kit but I'm temped to have a go at some winter white wash and the wasp is cooler than the shark mouth 😎
Was going to do the Battle of Britain version of this kit but I'm temped to have a go at some winter white wash and the wasp is cooler than the shark mouth 😎
18 September, 11:56
István Szücs
I also have Bf-110 from the Airfix, I will build an Italian night fighter. The sprues are the same, so I'm watching!
I also have Bf-110 from the Airfix, I will build an Italian night fighter. The sprues are the same, so I'm watching!
18 September, 19:08
Sy Bar
Cheers guys.
I'm have a go at riveting, but going freehand as at this scale using tape was taking so long. I also not sure how much they will stand out on finish kit, but with the wonky line in parts they will probably bee seen from mars 🤣
Cheers guys.
I'm have a go at riveting, but going freehand as at this scale using tape was taking so long. I also not sure how much they will stand out on finish kit, but with the wonky line in parts they will probably bee seen from mars 🤣
22 September, 10:15
Sy Bar
Cheers #Guy 👍
#Skyhiker I found the fit to be good, I had a very slight gap at the front but think that was as much to do with me and the fitting of the pit (not the clearest instructions there). Every thing else was fine and the canopy was a good fit, I did change order of build slightly with the tail section I glued the rear piece to the body first then added the tail (after I'd added the stabilisers/rudders) this made more sense than the instructions 😁
Cheers #Guy 👍
#Skyhiker I found the fit to be good, I had a very slight gap at the front but think that was as much to do with me and the fitting of the pit (not the clearest instructions there). Every thing else was fine and the canopy was a good fit, I did change order of build slightly with the tail section I glued the rear piece to the body first then added the tail (after I'd added the stabilisers/rudders) this made more sense than the instructions 😁
24 September, 21:32
Sy Bar
Only issue I have with this kit are the decals. While they look great and are in perfect register, they have a large amount of film edging and are both thick and delicate at the same time🤪
Having a hard time getting them to settle into the panel lines etc. I usually just need to use micro sol but even ultimate extra strong is not have much effect. Going to have to wait till I get some Tamiya fixer, strong and extra strong hopefully one of these will help 🤞
Only issue I have with this kit are the decals. While they look great and are in perfect register, they have a large amount of film edging and are both thick and delicate at the same time🤪
Having a hard time getting them to settle into the panel lines etc. I usually just need to use micro sol but even ultimate extra strong is not have much effect. Going to have to wait till I get some Tamiya fixer, strong and extra strong hopefully one of these will help 🤞
24 September, 21:44
Mr D
You should be ok with the medium one with Airfix decals,
I like a mix of Water in with the markfix...seems to keep the decal floating longer.
I did the teeth on my p40 this way.
If they started getting bit sicky...l would add bit more water....keep it floating.
Wouldn't like to do shark teeth with HB decals 🤔🤣.... The lightning ⚡ strike on my mig-15 just fell apart with hardly any working.
Good luck with it ..look forward to seeing 😃👍👍
You should be ok with the medium one with Airfix decals,
I like a mix of Water in with the markfix...seems to keep the decal floating longer.
I did the teeth on my p40 this way.
If they started getting bit sicky...l would add bit more water....keep it floating.
Wouldn't like to do shark teeth with HB decals 🤔🤣.... The lightning ⚡ strike on my mig-15 just fell apart with hardly any working.
Good luck with it ..look forward to seeing 😃👍👍
27 September, 13:53
Mathias Decommere
dodał nowy album.
dodał nowy album.
45 zdjęć/zdjęcia
Unexpected Resistance - Weserübung Süd - Hokkerup Denmark - 9th april 1940 - Final Album1:35
Projekt: 4. Unexpected Resistance
24 17 April, 06:29
Bruce Huxtable
You've been as busy as your cast of players! Creativity plus modelling skills well demonstrated 🙂 Congratulation s🙂
You've been as busy as your cast of players! Creativity plus modelling skills well demonstrated 🙂 Congratulation s🙂
21 April, 18:24
Connor Macleod
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
Avro CF-105 "Arrow"
Miniwing 1:144
Mini007 28 September, 11:38
Tommy Agne
dodał nowy album.
dodał nowy album.
28 21 July, 09:38
Tommy Agne
Thx Maciej and Giorgos for stepping by✌️. Now comes the hardest part: cutting masks for the markings 😬. So stay tuned...
Thx Maciej and Giorgos for stepping by✌️. Now comes the hardest part: cutting masks for the markings 😬. So stay tuned...
18 August, 11:41
Tommy Agne
Hi Mates, ✌️. I'll call this one done. Thank you all for stepping by and follwing.
Hi Mates, ✌️. I'll call this one done. Thank you all for stepping by and follwing.
8 September, 15:00
John
Very nice aggressor scheme and dio Tommy! 👍 Did you do the tarmac surface or is it a kit? Either way, it looks cool. Great figures and accessories too.
Very nice aggressor scheme and dio Tommy! 👍 Did you do the tarmac surface or is it a kit? Either way, it looks cool. Great figures and accessories too.
8 September, 15:44
Tommy Agne
Tank you Edouard, John and Guy ✌️.
@John: The Tarrmac ist from Uschi Van der Rosten.
Tank you Edouard, John and Guy ✌️.
@John: The Tarrmac ist from Uschi Van der Rosten.
8 September, 19:51
/pl/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=pl
35
35
/pl/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo