modelarska baza danych | zarządzanie magazynem

Wiadomości

 
The Blytonian
posiada ten przedmiot
50-014
Plunger & "O" Ring
Badger 1:1
50-014
3 November, 23:12
olivier77
chciałby nabyć ten przedmiot
15761
M3/M3A1 STUART
Italeri 1:56
15761 2016 Nowe formy
3 November, 23:12
olivier77
chciałby nabyć ten przedmiot
15768
Italian Tanks & Tank Destroyers (M13/40, M14/41, M40 da 75/18 mm, M41 da 75/18 mm)
Italeri 1:56
15768 2020 Nowe formy Więcej niż jeden temat (3)
3 November, 23:12
Ben M
dodał nowy album.
28 15 September, 20:10
Snake Plissken
Wow, chrome plated!
15 September, 21:10
Ben M
Taking it on vacation with me to get it started.
20 September, 01:55
Nathan Dempsey
Bearcats unite! Following 👀
20 September, 16:01
Guy Rump
Following. 👍
20 September, 17:51
Snake Plissken
Is it similar to a commemorative edition or just meant to replicate natural metal finish?
20 September, 20:05
Ben M
It's aluminum plated to represent the actual nmf finish. I built a t-33 where I had some issues that I hope to improve upon.
21 September, 04:29
Ben M
Did a lot of sanding areas that will be glued, masking, fitting parts to each other, and basic assembly while I'm on vacation. I got new decals from Siam decals as the originals are from 1968 and not in good shape. I'm not sure how old the Siam decals are but they are newer than '68. One thing that is apparent is the stripey tail decal doesn't fit at all. This is going to be a good challenge to resolve.
21 September, 23:57
Robert Podkoński
Taking a seat here.
28 September, 05:52
Ben M
Decided to try to apply the 1960s decal for the cockpit, as I don't have an alternative. Had to soak it for about a minute in hot water to get it to release. As is typical for hawk kits the decal isn't the right size but you go to war with the decals you have. I got it to apply without shattering. Unsure if it will stick, very old decals like this often have to be glued in place.
6 October, 15:19
Neil
Interesting 🤔 following also, looking good 👍
9 October, 09:56
Ben M
I think the Siam Scale decals I'm using instead of the originals are about 20 years old but they're going on ok. A little thick, so not settling down into panel lines but I'll try some decal fluid once they set in place, hopefully they will on the aluminum surface! The roundels are two part so I will have to do a second layer…
26 October, 22:30
Mr D
Smart little model.... unusual in the factory chrome 👍👍
Nice classic kit.
Bit of heat of hairdryer works with thick decals.... nice n steady.
Like it 😁👍
27 October, 15:36
Ben M
That's a good idea, I may give it a try. First I'm going to upgrade from micro sol to mark fit.
27 October, 15:56
Mr D
I use Mark fit ....but recently found the Vallejo one works amazing... Just used it on my in progress IAR-80.
Definitely my go to now.
The moon ships is great 👍👍
27 October, 16:15
Nathan Dempsey
Wow Ben this one is turning into a colorful bird.
27 October, 22:04
Ben M
An interesting detail I note while decaling. The panel lines on the fuselage are engraved. The panel lines on the wings are raised. Wtf.
28 October, 01:52
Desert Marlin
I've been using Mr. Mark Softener and Mr. Mark Setter. They worked well on some Kitty Hawk decals which are pretty stubborn...
28 October, 04:19
gorby
Nice work so far.
28 October, 09:02
Ben M
The tamiya mark fit and some work with a needle solved the problems! Thanks for all the great ideas everyone. Onwards!
28 October, 16:13
Ben M
Did a bunch of cut the decals into pieces to fit a different model than they were made for. Came out fairly well. Subassemblies are getting larger as the project comes together.
3 November, 03:49
Dave
Looks great. Nice work
3 November, 04:10
Desert Marlin
You seem to have forced the decals to cooperate!
3 November, 04:38
Robert Podkoński
Great job, Ben!
3 November, 07:41
Mr D
It's looking really good 👍
It's great that the kits can still be built after all these years.
The people in the factory's would have never believed the model they are packing wouldn't be built until 2024 🤔🤣.
Nice build to follow 😃
3 November, 21:52
Ben M
Almost complete. Popped the main fuselage seam a bit 🙁 I had gone to a lot of work to hide it. For some reason even after carefully scraping the mating surfaces I just don't get good adhesion. Maybe next time I will try only using CA for assembly on my next plated kit.
3 November, 22:06
Siger Van der wal
posiada ten przedmiot
1367
IDF
M60A1 Blazer with KMT-4 Mine Roller
Academy 1:35
1367 1994 Nowe części
3 November, 23:08
Ctihomir
posiada ten przedmiot
61109
Dewoitine D.520 "French Aces" w/Staff Car
Tamiya 1:48
61109 (61109-1800) 2011 Nowe części Więcej niż jeden temat (1!!)
3 November, 23:06
Le Yéti
posiada ten przedmiot
BF-004
Supermarine Spitfire Mk.Vb
Border Model 1:35
BF-004 2023 Nowe formy
3 November, 23:06
case
chciałby nabyć ten przedmiot
07408
2010 International Lonestar
Revell 1:25
07408 (80-7408) 2012 Nowe kalkomanie
3 November, 23:05
case
chciałby nabyć ten przedmiot
1300
International Lonestar
Moebius Models 1:25
1300 2011 Nowe formy
3 November, 23:05
Sylvain Hiret
Zacząłem tą rzecz
35212
BANTAM 40 BRC
UA MiniArt 1:35
35212 2017 Nowe części
3 November, 23:05
case
chciałby nabyć ten przedmiot
1301
International Prostar
Moebius Models 1:25
1301 2013 Nowe formy
3 November, 23:04
The Blytonian
posiada ten przedmiot
50-015
Air valve screw
Badger
50-015
3 November, 23:03
The Blytonian
posiada ten przedmiot
T8081
Omni Needle
Badger
T8081
3 November, 23:03
David Matiko
posiada ten przedmiot
3210
Bf 110D/E "Nachtjäger" Warbirds Series
Dragon 1:32
3210 2010 Nowe części
3 November, 23:00
John Novak
chciałby nabyć ten przedmiot
PSSP01-M02
Edelweiss Experimental Tank - Metal Antenna Set
Zoukei-Mura 1:35
PSSP01-M02 (SWPSSP01-M02) 2014 Nowe formy
3 November, 22:59
TommyMey
chciałby nabyć ten przedmiot
35376
M18 Hellcat U.S. Tank Destroyer
Tamiya 1:35
35376 (376) 2022 Nowe formy
3 November, 22:58
Richard
chciałby nabyć ten przedmiot
RM-5129
M109A7 Paladin Self-Propelled Howitzer
Rye Field Model (RFM) 1:35
RM-5129 (5129) 2024* Nowe formy
3 November, 22:58
TommyMey
chciałby nabyć ten przedmiot
3 November, 22:58
Harm Tiggelaar
posiada ten przedmiot
2184
Sd.Kfz. 250/1
Takom 1:35
2184 2024 Nowe formy
3 November, 22:56
MR556
chciałby nabyć ten przedmiot
81786
Russian MiG-29K
HobbyBoss 1:48
81786 2023 Nowe formy
3 November, 22:56
olivier77
chciałby nabyć ten przedmiot
2518SP
Macchi M.C. 202 Folgore w/Platz original photo-etched parts
Italeri 1:32
2518SP 2024 Nowe części
3 November, 22:54
olivier77
chciałby nabyć ten przedmiot
2518
Macchi M.C. 202 Folgore
Italeri 1:32
2518 2023 Nowe formy
3 November, 22:54
MR556
chciałby nabyć ten przedmiot
QD48460
F4U-2 Corsair interior 3D decals for Magic Factory Kit
Quinta Studio 1:48
QD48460 2024 Nowe formy
3 November, 22:54
olivier77
chciałby nabyć ten przedmiot
2516
Macchi C.200
Italeri 1:32
2516 2024* Nowe formy
3 November, 22:54
MR556
chciałby nabyć ten przedmiot
QD48460
F4U-2 Corsair interior 3D decals for Magic Factory Kit
Quinta Studio 1:48
QD48460 2024 Nowe formy
3 November, 22:54
Tim Powell
dodał nowy album.
9 26 October, 17:57
Martin Oostrom
This I need to see!
26 October, 18:24
Tim Powell
I'm slowly plugging away….itll be essentially OOB
26 October, 19:30
Mona
taking a seat 👀
26 October, 19:50
Bozzer
This is a great kit, I have almost every version of it, in the Revell range. Building up the turbo can be a little tricky, but I don't remember anything too bad about it? Those chrome lights that fit on the back of the sleeper, could've been designed better, to fit? Oh, the tyres are a bit thin, so if you can source some different ones, you will be happy.
27 October, 14:04
Tim Powell
Yeah, I've got most of the Revell kits. Building this to attach to my Dunkin' Donuts trailer
27 October, 14:30
Bozzer
I had to build custom drawers, for my trailer storage. With space fastly running out, it was the only solution. As my stash decreases, more shelves will be going up. Now I really need to stop collecting and start building! Looking forward to seeing your trailer on the back of this though 👍
27 October, 15:36
Robert B » Żądania funkcji
A way to ask a general questions to members about modeling topics. For instance I have in my stash the GWH L4822 dual role F-15E, but the older box art version. Now there is a newer box art (white background)version with the same SKU and UPC codes. They appear to have the identical wording on the boxes.
It would be great to have a way to reach out to other Scalemate members and ask question like the one above. Like a forum…..
5 October, 22:44
Spanjaard
there used to be possible to post things "as a question" but seems not longer possible. i think that was a great thing, and it will be great to have that back, so you can filter the newsfeed only on questions and see if you can help others, or if the question has been asked and answered already.
3 November, 22:52
Tiago Reis
chciałby nabyć ten przedmiot
12645
F40 LM
Fujimi 1:24
12645 (RS-114) 2016 Nowe pudełko (wznowienie)
3 November, 22:52
Jordan Giddins
chciałby nabyć ten przedmiot
ED-48140
Hawker Hurricane Mk.IIb Collection
Euro Decals 1:48
ED-48140 2024 Nowe formy
3 November, 22:51
BARY
posiada ten przedmiot
RM-5001U
Tiger I Initial Production Early 1943 North African Front/Tunisia
Rye Field Model (RFM) 1:35
RM-5001U 2021 Nowe części
3 November, 22:51
olivier77
chciałby nabyć ten przedmiot
6870
Battlefield Accessories
Italeri 1:32
6870 2006 Nowe formy Więcej niż jeden temat (4)
3 November, 22:50
Peter chiu
Zacząłem tą rzecz
03908
Hawker Hunter FGA.9
Revell 1:72
03908 2018 Nowe kalkomanie
3 November, 22:50
Peter chiu
posiada ten przedmiot
RF7213
Hawker Hunter
RAFDec 1:72
RF7213 Więcej niż jeden temat (5)
3 November, 22:49
BARY
posiada ten przedmiot
RM-5001U
Tiger I Initial Production Early 1943 North African Front/Tunisia
Rye Field Model (RFM) 1:35
RM-5001U 2021 Nowe części
3 November, 22:48
/pl/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed

search-solr.php?lang=pl

35

35

/pl/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed

35

todo