Wiadomości
Ingo F
dodał nowy projekt.
dodał nowy projekt.
4 5 October, 19:15
Tom B.
Nice 👍 Definetly following that! Part of me wishes for Revell to renew their Boxer line with the new Bundeswehr variants (Waffenträger and this one) at some point, but until the impossible happens it will likely come down to conversions. Curious to where you´ll source the Skyranger turret...
Nice 👍 Definetly following that! Part of me wishes for Revell to renew their Boxer line with the new Bundeswehr variants (Waffenträger and this one) at some point, but until the impossible happens it will likely come down to conversions. Curious to where you´ll source the Skyranger turret...
6 October, 14:10
Ingo F
Welcome on board mates.
@Tom B - Found the STL files for free here: cults3d.com/de/model..30-turret-look-alike
Welcome on board mates.
@Tom B - Found the STL files for free here: cults3d.com/de/model..30-turret-look-alike
6 October, 15:49
John Wiersma
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
MH-53E Sea Dragon U.S. Navy Mine Hunter & Combat Transport
Academy 1:48
12703 2023 Nowe pudełko (wznowienie) 6 October, 18:54
Tony May
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
IJN Ground Crews with Gunners Model Set (1)
Triumph Model 1:72
F72003A 2024 Nowe formy Więcej niż jeden temat (2)6 October, 18:50
Jerry Branca
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
Plastic Water jerry cans Vietnam 30
Callsign Models 1:35
CS35081 6 October, 18:48
Stryker3285
posiada ten przedmiot
posiada ten przedmiot
Soya Antarctica Observation Ship, Antarctica Observation 1st Corp
Hasegawa 1:350
40064 2006 Nowe formy 6 October, 18:47
Friedrich
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
Gustav Pt. 3 Bf 109G-6/AS & Bf 109G-14/AS Dual Combo | Limited Edition
Eduard 1:72
2150 2024* Nowe części 6 October, 18:46
J35J
dodał nowy album.
dodał nowy album.
18 zdjęć/zdjęcia
SAAB S-17BSNowy: 6 October, 15:04 1:48
Engine painted & weathered, ready for assembly
Projekt: Saab S-17BS
24 7 June, 15:09
J35J
Initial test fitting started. Will require more sanding and putty that expected for such a new kit.
Initial test fitting started. Will require more sanding and putty that expected for such a new kit.
13 July, 11:38
John
Cool subject and nice start 👍 Test fitting is half the "fun" on these limited run kits.
Cool subject and nice start 👍 Test fitting is half the "fun" on these limited run kits.
15 July, 03:40
J35J
Thanks John, test fitting can be quite rewarding for the rest of the build if you take your time and have some patience.
Thanks John, test fitting can be quite rewarding for the rest of the build if you take your time and have some patience.
15 July, 11:03
Mr D
dodał nowy album.
dodał nowy album.
63 zdjęć/zdjęcia
Romanian lAR-80 Fighter Nowy: 6 October, 13:46 1:48
Just the underside decals to do next, then a clear coat... really for a oil wash.
Projekt: Hobbyboss IAR-80
26 13 August, 21:46
Mr D
Thanks, Appreciate the interest, lm reality new to the hobby about 14 months, finding my way with techniques.
Weathering n panel lines need more learning.
The IAR-80 was decent price from HB and liked the paint scheme...bit different
👍👍
Thanks, Appreciate the interest, lm reality new to the hobby about 14 months, finding my way with techniques.
Weathering n panel lines need more learning.
The IAR-80 was decent price from HB and liked the paint scheme...bit different
👍👍
18 August, 13:25
Mr D
Thanks J35.
Nice to have the interest, HB instructions bit weak!
They said to paint interior charcoal black like on the FW-190.
But l checked n the Romanian lAR interior was grey/blue.
Engine building next 6 parts deal.
Cheers 😃👍
Thanks J35.
Nice to have the interest, HB instructions bit weak!
They said to paint interior charcoal black like on the FW-190.
But l checked n the Romanian lAR interior was grey/blue.
Engine building next 6 parts deal.
Cheers 😃👍
20 August, 11:14
Mr D
Good to have you along Miguel, engine n wings next,
A small amount of the wing is seen through bottom of cockpit, the HB instructions didn't mention painting it first!!
But the fit of the model be ok so far.
👍👍
Good to have you along Miguel, engine n wings next,
A small amount of the wing is seen through bottom of cockpit, the HB instructions didn't mention painting it first!!
But the fit of the model be ok so far.
👍👍
21 August, 09:08
Miguel Vaquero
Love the idea of filling with acrylic, never thought about it. Does it hold well though time?
Love the idea of filling with acrylic, never thought about it. Does it hold well though time?
26 August, 13:14
Mr D
Hi, Yes lve used it alot and holds up really well , l find the fillers a bit messy and more trouble than it's worth on small gaps.
You do need to allow overnight drying with it for best sanding results.
😀👍
Hi, Yes lve used it alot and holds up really well , l find the fillers a bit messy and more trouble than it's worth on small gaps.
You do need to allow overnight drying with it for best sanding results.
😀👍
26 August, 13:42
Doubtingmango
Brilliant! The putty really can create a mess with finely molded details
Brilliant! The putty really can create a mess with finely molded details
26 August, 15:01
Mr D
Yes it has a habit of filling in panel lines n bits not necessary!!
This technique is same as using alot of paint to fill a gap or high build primer ect...just becomes part of the paint layer as it acrylic too.
But it's not for big gaps!! As there is a bit of shrinking overnight.
Be onto marking rivets next step after sanding... Then need to make choices on open or closed canopy???
Yes it has a habit of filling in panel lines n bits not necessary!!
This technique is same as using alot of paint to fill a gap or high build primer ect...just becomes part of the paint layer as it acrylic too.
But it's not for big gaps!! As there is a bit of shrinking overnight.
Be onto marking rivets next step after sanding... Then need to make choices on open or closed canopy???
26 August, 19:18
Kesa Tiho
If anyone dare look away from that then every romanian within a 20 km radius will undo all your progress like a bunch of wolves eating a sheep
If anyone dare look away from that then every romanian within a 20 km radius will undo all your progress like a bunch of wolves eating a sheep
26 August, 19:29
Mr D
Thanks Mike 👋😀👍.
Ive got the canopy on now, HB do nice clear glass, so I'm having a closed cockpit,
So bit of masking to do there next.
Ive got X2 builds on the go at min.
All the best 👍👍
Thanks Mike 👋😀👍.
Ive got the canopy on now, HB do nice clear glass, so I'm having a closed cockpit,
So bit of masking to do there next.
Ive got X2 builds on the go at min.
All the best 👍👍
30 August, 19:09
Miguel Vaquero
I got to get myself a chrome pen. The result on those details look awesome
I got to get myself a chrome pen. The result on those details look awesome
4 September, 09:53
Mr D
Thanks Miguel, the pen needs a good shake prior to use , if it awkward area you can pump some out n use brush...but work fast.
Best to put a clear over next day as it's bit delicate.
Thanks Miguel, the pen needs a good shake prior to use , if it awkward area you can pump some out n use brush...but work fast.
Best to put a clear over next day as it's bit delicate.
4 September, 09:58
Alexander Perov
Do not forget that the mast of the antenna passes through the windshield and is very clearly visible. This model may come in handy in my albums
Do not forget that the mast of the antenna passes through the windshield and is very clearly visible. This model may come in handy in my albums
18 September, 19:29
Mr D
Ok thanks Alexander, HB didnt make the Mast installation very clear, the show it just glued on the top, will be very weak!! I've seen one build and it's come away!!
I'm going to use steel rod.
👍👍
Ok thanks Alexander, HB didnt make the Mast installation very clear, the show it just glued on the top, will be very weak!! I've seen one build and it's come away!!
I'm going to use steel rod.
👍👍
18 September, 19:59
/pl/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=pl
35
35
/pl/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo