Wiadomości
ser_igel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
Mercedes AMG GT3 Door & Engine Detail Kit for Tamiya 24345 & 24350 (Resin + PE + Metal Logo + Metal Parts)
Hobby Design 1:24
HD03-0548 20xx Nowe formy 16 September, 04:43
Stuart T
posiada ten przedmiot
posiada ten przedmiot
Ford Falcon XW GT Bonnet Stripe Mask for DDA Ford Falcon XW GT
Lazy Modeller 1:24
XWGT 2024 Nowe formy 16 September, 04:39
Andreas Gundhe
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
F-16AM Block15 Ukraine AFw/ Terma PIDS+ Pylons Kiev Vasilyev Air Base Aug 2024
Fab Scale 1:48
FD48014 2024 Nowe formy 16 September, 04:38
Andreas Gundhe
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
F-16CM Block42 Dark Viper 112nd FS & 180th FW Toledo Express Airport 2024"
Fab Scale 1:48
FD48016 2024 Nowe formy 16 September, 04:38
Peter Kallenbach
posiada ten przedmiot
posiada ten przedmiot
Grumman F-14 Tomcat Cold Lake, Alberta, Canada, October 1977
Warbird Decals 1:48
48045 2020 Nowe formy 16 September, 04:38
Peter Kallenbach
posiada ten przedmiot
posiada ten przedmiot
F-15C Eagle Oregon ANG 173rd FW
Warbird Decals 1:72
72041 16 September, 04:38
Marcin Dudek
dodał nowy album.
dodał nowy album.
3 15 September, 15:32
Marcin Dudek
A new build starte 🙂. It seems quite easy but one thing puzzles me - the tracks. They compose of 4 straight plastic parts and instruction says to bend them with hair dryer. It is first time I encountered this type of tracks. Anyone tried doing something like this?
A new build starte 🙂. It seems quite easy but one thing puzzles me - the tracks. They compose of 4 straight plastic parts and instruction says to bend them with hair dryer. It is first time I encountered this type of tracks. Anyone tried doing something like this?
15 September, 15:36
Snake Plissken
I have heard of this type of assembly but have never built one. However, I have lots of experience heating and softening styrene plastic. You can also try very hot or boiling water -- soak the tracks in boiling water, then fish them out of the water with long tweezers and bend them around the rear sprocket, idler and road wheels and hold until they cool. You may even get by using no heat, just slowly and carefully bend curves into the tracks.
I have heard of this type of assembly but have never built one. However, I have lots of experience heating and softening styrene plastic. You can also try very hot or boiling water -- soak the tracks in boiling water, then fish them out of the water with long tweezers and bend them around the rear sprocket, idler and road wheels and hold until they cool. You may even get by using no heat, just slowly and carefully bend curves into the tracks.
15 September, 20:46
/pl/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=pl
35
35
/pl/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo