Ścianka
Wall
Qwertzel
dodał nowy album.
dodał nowy album.
16 zdjęć/zdjęcia
Revell Airbus H145 ADAC LuftrettungNowy: 14 July, 16:24 1:32
The hole in the roof is for LEDs
Projekt: Revell Airbus H145 ADAC Luftrettung
8 7 June, 15:25
John
Cool! I was wondering how all the extra parts in mine looked when done, very nice. 👍
If you will accept a bit of advice, when you complete the cabin "shell" that goes into the fuselage halves, be prepared to do a lot of trimming and fitting before closing up. On mine, the sides of the fuselage wanted to push the roof of the cabin down and also hit the edges of the windscreen opening and that left a big gap on top. I finally got it acceptable fit, but even then, I wish I had cut more away because the cabin roof does not quite fit flush.
Cool! I was wondering how all the extra parts in mine looked when done, very nice. 👍
If you will accept a bit of advice, when you complete the cabin "shell" that goes into the fuselage halves, be prepared to do a lot of trimming and fitting before closing up. On mine, the sides of the fuselage wanted to push the roof of the cabin down and also hit the edges of the windscreen opening and that left a big gap on top. I finally got it acceptable fit, but even then, I wish I had cut more away because the cabin roof does not quite fit flush.
20 June, 15:34
Qwertzel
Thanks for the advice. I'll take care of it 🙂
I build a lot of Revell kits in the past and the fitting was different with every model. I have got everything between pretty good and horrible. It's always like a mysterious box.
Thanks for the advice. I'll take care of it 🙂
I build a lot of Revell kits in the past and the fitting was different with every model. I have got everything between pretty good and horrible. It's always like a mysterious box.
20 June, 16:28
John
I'm sure you will do well with all that Revell experience. 👍 The good news is that other than the cabin shell, the rest fits OK (ish) even the windscreens. But if you want doors closed, also be prepared to do some surgery on them.
I'm sure you will do well with all that Revell experience. 👍 The good news is that other than the cabin shell, the rest fits OK (ish) even the windscreens. But if you want doors closed, also be prepared to do some surgery on them.
20 June, 17:35
July 10, 2024
Qwertzel
dodał nowy album.
dodał nowy album.
13 4 April, 16:38
DerSchottologe
I see you've left the license plate holder on. I should have done the same! I tried to remove it as requested in the instructions by "sanding it off" but my result isn't very good. The whole rear side looks a bit rough now haha.
I see you've left the license plate holder on. I should have done the same! I tried to remove it as requested in the instructions by "sanding it off" but my result isn't very good. The whole rear side looks a bit rough now haha.
10 July, 22:07
June 26, 2024
June 23, 2024
June 22, 2024
June 21, 2024
June 20, 2024
June 7, 2024
June 4, 2024
May 30, 2024
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
5t Pallet Truck & Wooden Pallet with 200 Litre Oil Drum and Plastic Barrel
Gecko Models 1:35
35GM0034 2023 Nowe formy Więcej niż jeden temat (3)30 May, 11:36
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
Traffic Cones & Lights (Large)
Accurate Armour 1:35
A097 30 May, 11:35
May 27, 2024
May 20, 2024
May 18, 2024
May 17, 2024
May 15, 2024
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
US Army Light Type III Skid Steer Loader (M400W) with Bar Track
Gecko Models 1:35
35GM0009 2022 Nowe części 15 May, 08:43
May 14, 2024
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
Styrene Sheet 2.0mm thick x 245 x 195mm (1 unit)
AK Interactive
AK 6578 14 May, 09:11
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
.010 inch (0.30mm) Clear Styrene Sheet 3 x Clear Styrene Sheets (175x300x0.30mm)
Plastruct
91201 (SSM-101) 14 May, 09:10
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
ABS Plasticard - Profile - 20x RODs Variety Pack
Green Stuff World 1:48
9200 Więcej niż jeden temat (1!!)14 May, 09:08
May 13, 2024
May 12, 2024
May 9, 2024
May 8, 2024
May 5, 2024
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
Heavy tread front tire 385/65 R22.5
A&N Model Trucks 1:24
ANMT-75 5 May, 18:08
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
4×4 chassis for German construction truck
A&N Model Trucks 1:24
ANMT-79 5 May, 18:08
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
8×8 chassis for German construction truck
A&N Model Trucks 1:24
ANMT-80 5 May, 18:08
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
German Construction Truck to use Italeri Mercedes Benz Actros MP4
A&N Model Trucks 1:24
ANMT-68 2018 Nowe formy 5 May, 18:07
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
Dodge RAM 2500 Power Wagon Pickup Truck
A&N Model Trucks 1:24
ANMT-112 5 May, 18:06
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
Mercedes Sprinter Third Generation
German panel van, 5.5 ton, normalA&N Model Trucks 1:24
ANMT-111 2020 Nowe formy 5 May, 18:06
May 4, 2024
May 3, 2024
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
Working Vehice
Fire Ladder Truck Otsu Municipal Fire Department Aoshima 1:72
059708 (03) 2020 Nowe kalkomanie 3 May, 19:56
April 30, 2024
April 27, 2024
Qwertzel
chciałby nabyć ten przedmiot
chciałby nabyć ten przedmiot
Car Fire Extinguisher
Scale Production 1:24
SP24026 27 April, 20:45
wnolder.php?lang=pl
2024-04-27 13:41:34
2024-01-02 14:56:05
137072
/ajax/wnolder.php?lang=pl&sd=2024-04-27 13:41:34&md=2024-01-02 14:56:05&filter=&w=137072
todo