build
The Cockpit OOB is a little bit boring
so i cut off part in the back and create with copper wires and plastic-sheets a little bit „busy-ness“
the seats in the kit are pretty nice!??
then i build a new glare-shield also from styrene and stretched sprues
i create some hydraulic-hoses with copper-wire
the Intruder stand on his own legs.
The overall fit of the kit is not too bad! Some filler is needed arround the front-section in the area of the windshield, a little bit on the wing-roots and a tiny Bit on the belly of the bird.
The overall fit of the kit is not too bad! Some filler is needed arround the front-section in the area of the windshield, a little bit on the wing-roots and a tiny Bit on the belly of the bird.
Komentarzy
23 28 March, 17:58
Denis Dogadov
It's a good start, but there's still a lot of work to do, but I paid more attention to the air intake and exhaust channels of the engine.
karopka.ru/community/user/21568/?MODEL=637130
It's a good start, but there's still a lot of work to do, but I paid more attention to the air intake and exhaust channels of the engine.
karopka.ru/community/user/21568/?MODEL=637130
3 April, 17:32