Honda Integra(DC5) - WIP Part01
cutout
cutout
cutout
trimming and polishing
panel lining
panel lining
white surfacing
drawing air intake hole
cutout air intake hole
cutout air intake hole
detail-up air intake hole edge and painting gloss white
washed
cutout fin
compounding for transparent
triple overcoat clear
compounding and water washing
compounding and water washing
compounding and water washing
compounding and water washing
ready for painting semi gloss black
masking
painting semi gloss black
take off masking tape
painting flat, semi gloss black to another parts
take off masking tape and water washing
masking again for silver, red painting
trimming rough painted area
light weathering with tamiya weathering master
roughly painting and weathering
paint brushing
painting rear lamp and side winker
making side winker on fender
punching '3M' mirror tape
and stick to rear lamp
I don't know what is this... but I saw it on the box art
black lining to panel line
snipping nylon mesh
applying mesh
applying mesh
assembling wheels
applying decal and gloss coating
applying wheels
applying option metal transfer emblem
detail up harness with etching(option parts)
detail up harness with etching(option parts)
detail up harness with etching(option parts)
assembled
cockpit on the board
detail up with etching(option parts)
painting emblem etching(option parts)
attached
attached
applying metal transfer(option parts)
attached side winker
attaching rear bumper
and attaching front bumper and front lamp cover
and attaching rear lamp cover
detail side mirror with black of bandai pokemon sticker 🙂
sttaching side mirror
attaching rear wing
finish, but this kit had critical problem
that was strange proportion or wheel house
because too large wheel house or too small rims
because too large wheel house or too small rims
because too large wheel house or too small rims
anyway I'm done.
Komentarzy
7 November 2018, 09:53
Alexander GrivonevGreat, thanks! What paint and clearcoat do you use for the body?
7 November 2018, 11:44
