K-4386
1
November 14, 2020cooling holes are molded shut2
November 14, 2020started with thinning the edges, also for the fit of the replacement barrel3
November 14, 2020Next I used the fine Mr Scriber to follow the contours till the pieces could be pushed through4
November 14, 2020next up is making the hole even with a drill (used as a file, due to lack of such a small file) and then removing the burrs with the thin cement.5
November 14, 2020A bit better IMHO6
November 14, 2020Hull in dryfit... gives a whole new level to the concept of clickable parts... Was very doubtfull about that when I've first encountered this when they announced their GT-407
November 14, 2020all main parts can be taken apart for painting8
November 14, 2020rear part consists of 5 parts interlocking.. almost no seams9
November 14, 2020on the kit part is folded up, a small change to fold it down... simply cut away, enlarge the space between the bracket parts and reglue10
November 14, 2020loose parts, ready for primer11
November 14, 2020seats too.12
November 14, 2020a mean machine...13
December 30, 2020pieces ready for primer, so far, only the inside14
December 30, 2020and finished15
December 30, 2020The KAV-stuff has arrived... the green film is a hell... don't know what I'm doing wrong, but it has some slight glue on one side. I've cleaned the window parts and the table, but fot one reason it seams that there's always a bubble, some dirt, etc between the surfaces... So I've ended removing the glue and squeeze it like that between the window parts...
Komentarzy
4 14 November 2020, 07:13