Maschinen Krieger StingrayWidoczność: Pokaz slajdów Mozaika Lista 1February 3, 2021I haven't decided whether or not I should attach the cockpit, since I don't really want to have to scratchbuild the area around the cockpit tub 2February 12, 2021Close-up of the 105mm railgun 3February 3, 2021As you can tell, quite a bit of gray Tamiya Putty was required to smooth out the seams of the kit 4February 7, 2021The reactors required even more putty than the body of the spacecraft! I'm not looking forward to sanding these guys 5February 8, 2021And there's one sanded and detailed 6February 9, 2021Here's the dorsal spine attached to the underside of the rear frame. It's starting to finally look like a spaceship! 7February 10, 2021Main sub-assemblies(minus the massive railgun) attached 8February 12, 2021And here's a shot of the railgun (temporarily)attached to the underside 9February 17, 2021a side view that illustrates the sheer mass of this aircraft's armament 10February 16, 2021Engine bells and sensor dish are finished 11February 17, 2021Top view of the ship on its stand 12February 17, 2021A rear view displaying the engines 13March 10, 2021Turns out all that filling and sanding wasn't enough, as a coat of Mr. Surfacer Mahogany primer showed that there were still many gaps and seams 14May 4, 2021After several hours of applying putty and sanding, I'm free from the pain Komentarzy 18 3 February 2021, 02:08TorstenI must watch😎3 February 2021, 04:11JDCount me in! 👍7 February 2021, 03:59Norbert SteffensI'm in too7 February 2021, 07:56Luke HolstenThanks for the support!8 February 2021, 04:33S MFollowing! I also just started a Stingray project.14 February 2021, 15:13JDAh, the more beat up, the better, this is an Ma.k. build 👍10 March 2021, 04:29Project infoMaschinen Krieger Stingray14 zdjęć/zdjęcia1:35W trakcieWszystkie albumyWyświetl wszystkie albumy »