Galland 109E
Komentarzy
19 4 July 2021, 23:27
![](/profiles/img/62380-162-s.jpg)
Wasn't planning on it … but peeled the carrier film off the new type eduard decals 👍
15 November 2021, 10:08
![](/profiles/img/12696-s.png)
Bill it's looking the part as it is. 👍
did you use any setter / softener for the decals before peeling em off, if yes which one(s)?
taa.
18 November 2021, 07:41
![](/profiles/img/62380-162-s.jpg)
Murad - yes . I was only planning on clear coating them afterwards with dullcote so I painted with a lacquer paint for a base , no clear coat under decals, Microsol underneath and then walther's solvaset to bed them down . Left them for a day to dry and then noticed a couple of little bits lifting off so tried peeling them . Came off in nice chunks with tweezers and a fingernail. Dried another day and clear coat with dullcote for post shading and weathering
18 November 2021, 09:26
![](/profiles/img/62380-162-s.jpg)
murad - make that microset underneath the decals and solvaset over them ... i get the microscale stuff confused ...
18 November 2021, 20:32
![](/profiles/img/12696-s.png)
Bill thank you, afaik solvaset is relatively powerful softener - it's interesting and promising that the carrier film could still be peeled off.
iirc the first of horror stories with these eduard decals you should not need any softener at all etc. before this was a thing i remember removing eduard's in house decals' carriers with a worn out tamiya masking tape easily yet inconsistently... lotsa conflicting reports and experiences
19 November 2021, 02:42
![](/profiles/img/46636-566-s.jpg)
Well done! Wonderful scheme — excellent camo work. Glad you were able to have success with the decal film.
8 February 2022, 10:27