Ścianka
Wall
Robbe CasierZacząłem tą rzecz
WWII German Heavy Cruiser
Prinz Eugen 1945 - Super Detail Set for Trumpeter FlyHawk Model 1:350
FH350069 2014 Nowe formy 10 August, 10:41
April 19, 2024
April 18, 2024
February 25, 2024
January 31, 2024
January 29, 2024
January 28, 2024
January 25, 2024
ICM 1:350
December 30, 2023
November 30, 2023
Robbe CasierZacząłem tą rzecz
IJN DD Shimakaze - Final Ver. Detail Up Etching Parts for Hasegawa | Final Version Kit
Hasegawa 1:350
72157 (QG57) 30 November 2023, 14:20
November 23, 2023
November 19, 2023
November 18, 2023
Robbe CasierI'm almost finishing my first model and bumbed into an issue. For one of the last colours to be applied I wanted to use masking tape, but after trying to adjust, my other layers(including primer) came off. Did I use the wrong primer for this? The primer was from a DIY store. I was considering to use a different primer for my next model, because it is very thick and easely hides small details.
18 November 2023, 09:26
Antony MerigotI'm guessing that your primer might have been a little thick. A good thing to do would be to clean the plastic on the kit with isopropyl alcohol then apply the primer but make sure to thin down the primer.
18 November 2023, 10:08
Martin OostromAnd stick the masking tape to the back of your hand before applying. This slightly reduces the tackiness. Do not use the inside of your hands, too much grease and dirt.
18 November 2023, 11:28
Thomas Bischoff… and you are not alone - I also have this from time to time.
You can also use a fine sanding stick or paper to make the surface more rough which increases adhesion of the colour
18 November 2023, 12:00
wnolder.php?lang=pl
2023-11-18 12:00:08
2023-10-21 11:15:03
134136
/ajax/wnolder.php?lang=pl&sd=2023-11-18 12:00:08&md=2023-10-21 11:15:03&filter=&w=134136
todo