Rebels TIE Fighter
Front and rear detail pieces - masters were made using styrene (very small and fiddly) followed by moulding and casting the final versions
Also scribed the panel lines at the bottom of the ball.
Rear view, showing the engines
Finally got back to this one and finished the details on the fuselage - some styrene bits on the top hatch, the guns, and the detail pieces on the sides of the windshield.
Main painting done and wings glued on - now for decals and a bit of weathering
Comments
5 31 July 2017, 13:12
Uwe Kaeding
Finally got back to this one after a long lay-off. Looks like I've lost all of the captions on the old photos though.
Finally got back to this one after a long lay-off. Looks like I've lost all of the captions on the old photos though.
30 December 2020, 01:55
Torsten
WOW, pretty much work and very interesting to see all the details you made and add, really😎
WOW, pretty much work and very interesting to see all the details you made and add, really😎
30 December 2020, 16:40
Uwe Kaeding
Yep, lots of work - probably one of the reasons it went on hold for 4 years!
Yep, lots of work - probably one of the reasons it went on hold for 4 years!
31 December 2020, 01:14
Album info
This is a 1/72 model of the early TIE Fighter seen in the Rebels TV series. It is scratch-built using modified parts from both the Revell and Fine Molds TIE Fighter kits.