'71 Dodge Hemi Challenger R/T (resin)
Comments
Album info
This model was a difficult endeavor. The body was a resin copy that had a few of resin's typical issues, namely warping and thickness variances. It also was cast without an engine compartment or cowl. I used an AMT Yankee Challenge kit as a donor. With a lot of trimming, most all of the parts fit together. One of the challenges was having no grille or headlight frames. The 1970 parts are way too different to use so, I made them from scratch. The "floating" grille sections turned out so-so, but they do make it look like a 71 at least. The tail lights were drop in with minor trimming. (I think) the fake side scoops were sourced from Drag City Casting. The rear "Go Wing" came from an AMT 71 Duster Kit. The Hemi came from one of my Challenger kits or parts box (it has been a long time). The R/T stripes came from an ebay vendor. Too bad the artwork for the letters was slanted WRONG on the drivers side. (no way to fix it either). I would normally detail paint the rally wheels but after all the other battles, I just