German Flak Diorama
Comments
1 February 2020, 11:27

Interesting. Any trick to making sure the barrel sticks straight out without a tilt to either side? I have a similar project going on. 🙂 Haven't drilled out and glued on the metal barrels yet.
I wonder if maybe one can drill out a four-hole guide template, a piece of styrene, that can act as a guide for all four barrels. The four holes would then have to match the very locations of the plastic holes.
1 February 2020, 11:35

Hi Treehugger, I just drill slowly and the barrels I purchased have a good amount of material going into the original plastic gun, so they stay in place I didn't need glue. Once the armour piece is glue into place the barrels lined up perfectly. 😮)
7 February 2020, 13:09

BTW, I stared with a small sized drill bit, before going onto the 1mm
7 February 2020, 13:10