DH. 82A Tiger Moth SPACE
ICM
Eduard | No. 3DL32002 | 1:32
Fatos
- Marca:
- Eduard
- Título:
- DH. 82A Tiger Moth SPACE ICM
- Número:
- 3DL32002
- Escala:
- 1:32
- Tipo:
- Acessório
- Código de barras:
- 8591437557837 (EAN)
- Tópico:
- De Havilland DH 82 Tiger Moth » Hélice (Aeronave)
Conteúdo
Fotogravado (Multi-colored), Decals (3D) (Multi-colored)
O que está na caixa »Instruções
Download 3729Kb (.pdf)
Mercado
Lojas online
USD 11.96
Em estoque »USD 12.34
Em estoque »USD 13.49
Em estoque »USD 10.49
Disponível »USD 13.49
Disponível »AUD 17.50
USD 11.98Em estoque »Mostrar todas as ofertas » (13 no total)
SKUs alternativos para Eduard 3DL32002:
EDU3DL32002 | ED 3DL32002 | ED3DL32002 | 7397102
Nota: Preços e disponibilidade são apenas indicações. Verifique se o produto realmente corresponde à entrada!
Avaliações
Revisões externas
Propaganda
Comentários
Kenneth
I have bought this for my Revell re-pop of the 1/32 ICM Tiger Moth. It‘s very nice, but I do notice the following issues:
1) The lap belts are attached to the lower-most fuselage longerons, not halfway up the fuselage.
2) There are three throttle levers, but only two are shown in the instructions. The third one could be used as a mixture lever, but then only in the rear cockpit.
3) The harness locking pins and spring clips are too large and unrealistically two-dimensioal. Moreover, they are attached by strings to the shoulder belts, not the lap belts.
4) The shoulder belts are not directly attached to the panel behind the seats, but to a steel wire running in the indentation in each panel.
5) The upper edge of the required cut-out in each instrument panel for the compass should be curved, not straight.
It would be worthwhile checking some of the many walkarounds in the Internet, before using this set
I have bought this for my Revell re-pop of the 1/32 ICM Tiger Moth. It‘s very nice, but I do notice the following issues:
1) The lap belts are attached to the lower-most fuselage longerons, not halfway up the fuselage.
2) There are three throttle levers, but only two are shown in the instructions. The third one could be used as a mixture lever, but then only in the rear cockpit.
3) The harness locking pins and spring clips are too large and unrealistically two-dimensioal. Moreover, they are attached by strings to the shoulder belts, not the lap belts.
4) The shoulder belts are not directly attached to the panel behind the seats, but to a steel wire running in the indentation in each panel.
5) The upper edge of the required cut-out in each instrument panel for the compass should be curved, not straight.
It would be worthwhile checking some of the many walkarounds in the Internet, before using this set
21 January, 10:37
Material de referência
Todos os livros » (12 no total) Todos os <em>walkarounds</em> » (6 no total)