Notícias
scautomoton
possui este item
possui este item
BAC
TSR.2 - Intake FOD Covers & Exhausts for Airfix CMK (Czech Master Kits) 1:72
7189 2011 Produto novo 16 August, 13:23
Dmwilde
quer este item
quer este item
Kawanishi H8K2 Type 2 Flying Boat Model 12 '901st Flying Group'
Hasegawa 1:72
02473 2024 Novos decalques 16 August, 13:17
Bill C
will attend
will attend
Modelpalooza Saskatchewan 2024
18-20 Outubro 2024
18-20 Outubro 2024
15 August, 20:38
Ken Kolenovsky
Not sure where this listing came in Bill, but it is not the one I put on Scalemates. This one is listed under "Group Builds" and that isn't what I set it up as. I also see that there is a link to our Facebook site, but I didn't enter that. Curious.
Not sure where this listing came in Bill, but it is not the one I put on Scalemates. This one is listed under "Group Builds" and that isn't what I set it up as. I also see that there is a link to our Facebook site, but I didn't enter that. Curious.
16 August, 13:16
Simon Smith
possui este item
possui este item
Panzer Kampf Flugzeug 40
Fledermaus aka. Jagd Flugzeug 40(S) Nitto 1:20
SF3D Series 11 1984 Produto novo 16 August, 13:15
Alex Rakhimgulov
adicionou um novo álbum de fotos.
adicionou um novo álbum de fotos.
23 27 June, 09:04
Villiers de Vos
Very nice texturing and weld marks on this Soviet beast. The photo etch details is a nice touch.
Very nice texturing and weld marks on this Soviet beast. The photo etch details is a nice touch.
10 July, 02:10
Alex Rakhimgulov
Thank you, Mate! This photo etch is selfmade from 0.2mm brass plate ))) I need to buy the photo etch bender, to make it better. ))
Thank you, Mate! This photo etch is selfmade from 0.2mm brass plate ))) I need to buy the photo etch bender, to make it better. ))
10 July, 07:14
Alex Rakhimgulov
Thanks, Mate!
I try to make weld beads like on my favorite YT cannel )))
1) I make a groove with scraiber, if it necessary on the plane surfaces.
2) Next, i prepare 2 component putty, and make a thin "laces" out of it.
3) After that, I carefully fill the grooves and angles with putty "laces" and apply welding texture with special tool (toothpick with tip warped with brass sheet, witch forms small speared C shape).
That is all.
Thanks, Mate!
I try to make weld beads like on my favorite YT cannel )))
1) I make a groove with scraiber, if it necessary on the plane surfaces.
2) Next, i prepare 2 component putty, and make a thin "laces" out of it.
3) After that, I carefully fill the grooves and angles with putty "laces" and apply welding texture with special tool (toothpick with tip warped with brass sheet, witch forms small speared C shape).
That is all.
9 August, 09:30
/pt/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=pt
35
35
/pt/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo