HA-1.112-K1L Buchón 1:32
good fit in the 3d printed parts
Interior parts specifically designed for this buchon
Gunsight
Main panel, note the detail achieved.... but I'm not sure if I would be able to paint it
Rocket launcher box
printed parts in place
aded some detail in the ruder pedals
Some wires to add detail
instrument panel and rocket box almost painted
panel ready
Rocket launcher box ready
starting to play with interiors
need some washes but is close to finish
internal face of the canopy painted in interior colour
Cockpit weathered
3d printed Buckles for the seatbelts
seatbelts made with thin metal foil and the 3d printed buckles
dry test fit of the nose
thinlayer of paint to unify colours and check for imperfections
quine nice here
some minor imperfections on the panel lines should be repaired
the stitching on the rudder seems too big, I will sand it down a bit to improve it
Comentários
7 13 February, 19:37