Finished CF-18
![Album image #1 Album image #1](/albums/img/4/8/5/160485-18198-89-720.jpg)
![Album image #2 Album image #2](/albums/img/4/8/6/160486-18198-15-720.jpg)
![Album image #3 Album image #3](/albums/img/4/8/7/160487-18198-61-720.jpg)
![Album image #4 Album image #4](/albums/img/4/8/8/160488-18198-51-720.jpg)
Comentários
29 January 2015, 16:10
![](/profiles/img/user-s.jpg)
Nice build, didn't these have a searchlight on the lefthand side of the pilot?
[img1]
29 January 2015, 16:46
![](/profiles/img/18198-770-s.png)
Thanks. And yes some did have a searchlight (others had them removed after the cold war ([img1])). But that might be a great addition. Just have to figure out how to do that.
29 January 2015, 18:44
![](/profiles/img/user-s.jpg)
It's not that difficult, but if it's a first time... You can use some label tape ([img1]) to mask the panel, and then with a needle or sharp pin (for example : [img2]) you start scribing the inner contour without applying pressure and after a few passes you will feel the sciber tool will get some grip. Proceed till it's deep enough. When scribing along a line, it's good to start at the beginning of a line or in a corner, pull a line till almost at the end and finish the line from the other side. In this way you will avoid shooting over... After the scribing, finish by slightly sanding...
29 January 2015, 19:16