Antonov An-12 Turkish Cargo 1992-93
1
June 27, 20152
June 27, 2015In the meantime i broke lots of PE parts and had to fix them again.3
June 27, 20154
June 27, 20155
June 27, 2015Painting PE parts with acrylics is a difficult story6
June 27, 20157
June 27, 20158
June 27, 2015Painting the inside, why? Because...9
June 27, 2015... it will be visible. The winch itself consists of >20 PE parts, some of them smaller than 1mm10
June 27, 201511
June 27, 2015I'll try to make my own masks this time.12
June 27, 201513
June 27, 2015The joint of the rear fuselage part is problematic. More to come...14
June 27, 201515
June 27, 201516
June 27, 201517
June 27, 2015Altohugh i used lots of sandpaper, the joint is still visible... not finished18
June 27, 201519
June 27, 2015Sh!t the kit fell down from the table and broke at the joint. Used revell contacta+zap CA and the result is like concrete: not grindable with sandpaper20
June 27, 2015more sh!t: used dremel to grind the concrete(!) and the heat melted parts of the body. had to use lots of putty to fix it21
June 27, 2015his is the 2nd layer of putty.22
June 27, 2015Not a bad result for own made masks, could be better though
Comentários
27 June 2015, 21:01