"Dornier Classics" Project. Part II: The X
Comentários
6 9 July 2018, 07:51
Dmitriy Andreeshchev
Update! Assembled main structural parts. This model is way easier then the Wal from Amodel 🙂
Update! Assembled main structural parts. This model is way easier then the Wal from Amodel 🙂
22 July 2018, 15:56
Dmitriy Andreeshchev
An update: Completed the main body, restored the corrugated surfaces, masked! Started to work this engines - those require a lot of refinement!
An update: Completed the main body, restored the corrugated surfaces, masked! Started to work this engines - those require a lot of refinement!
7 August 2018, 17:25
Dmitriy Andreeshchev
Update: finished the engine subassembly! Very difficult part of the build, lots of cleanup and filler, and strut attachment between engines is extremely fiddly!
Update: finished the engine subassembly! Very difficult part of the build, lots of cleanup and filler, and strut attachment between engines is extremely fiddly!
11 August 2018, 18:03
Bernhard Schrock
Very remarcable result especially the NM finish! The numbers on upper side of wings: airbrushed or decals?
Very remarcable result especially the NM finish! The numbers on upper side of wings: airbrushed or decals?
14 August 2018, 04:02
Dmitriy Andreeshchev
Bernhard, I used decals from the kit. Even considering tha fact, that they were a bit old and with some cracks in them, they worked good. And thank you! My gratitude also goes to Alec K, Julian, bobinspokaloo and Spanjaard!
Bernhard, I used decals from the kit. Even considering tha fact, that they were a bit old and with some cracks in them, they worked good. And thank you! My gratitude also goes to Alec K, Julian, bobinspokaloo and Spanjaard!
14 August 2018, 08:34