Arado Ar-190
Comentários
31 14 March 2020, 13:08
![](/profiles/img/26441-134-s.jpg)
Why wasn't I informed of this project being under way?! Luckily, I scan Uwe's wall every so often to snoop on what he's up to. I've been thinking about this one as well. Great to have a step-by-step guide along the way.
8 April 2021, 13:54
![](/profiles/img/27411-254-s.jpg)
Thanks guys - started this one this time last year, so it's been moving slowly! Of course just after I started it special hobby released a new kit, so I probably could have saved the rescribing - but it was a good learning experience. Still some way to go on this though, including some changes to the canopy glazing.
9 April 2021, 06:42
![](/profiles/img/23938-707-s.jpg)
Following. Special Hobby has a new Ar 196??? Or were you thinking about the Sword kit?
19 September 2021, 14:29
![](/profiles/img/27411-254-s.jpg)
Thanks Alec - you're right, I must have been thinking of the Sword kit (I knew it was eastern European and started with S!)
19 September 2021, 22:38
![](/profiles/img/23938-707-s.jpg)
NP. Got me excited there for a minute. The Sword kit is apparently a bear to build, so the old Heller kit is still pretty good, raised panels and all.
20 September 2021, 01:39
![](/profiles/img/27411-254-s.jpg)
Well there you go - newer isn't always better! Might be a good thing I stuck with the Revell kit, particularly as I'm building a comic book representation anyway...
20 September 2021, 01:51
![](/profiles/img/26441-134-s.jpg)
That was my reasoning… it even kept me from rescribing the panel lines. 😉
I can't wait to see what Uwe's going to come up with here.
20 September 2021, 04:26
![](/profiles/img/27411-254-s.jpg)
Nearing the end, Greg - a bit more masking and then the final paint
20 September 2021, 04:51
![](/profiles/img/13010-177-s.jpg)
Nice build, I hold it for the same build in 1:32, follow with great interest 👍
2 October 2021, 06:15
![](/profiles/img/27411-254-s.jpg)
Thanks Torsten. Finally got around to finishing this one (the rigging on the floats held me up) and taking the final photos.
25 April 2022, 02:31
![](/profiles/img/27411-254-s.jpg)
Thanks Lukasz - always good when the cowling and prop boss only need to be grey! The propeller blades have been painted though 😉. Unfortunately I had to paint them because the kit plastic was a different shade of grey to the resin cowling!
25 April 2022, 12:55
Album info
This is the EFSR (European Foundation for Scientific Research) Ar-190 floatplane from the Tintin book The Shooting Star. Its based on the Revell 172 kit with an Eduard photo-etch set and a Quickboost cowling. As it is meant to be a civillian aircraft I've also tried to demilitarise it by getting rid of hard points and guns.