Новостная лента

Sy Bar
Was going to do the Battle of Britain version of this kit but I'm temped to have a go at some winter white wash and the wasp is cooler than the shark mouth 😎

Spanjaard
nice details 🙂

Villiers de Vos
A classic. Nice progress.

Stephen Lesley
Thank you Spanjaard and Villiers. Yes, a classic indeed, but as always with a few issues. As the saying goes "some days a diamond , some days a stone". Today was a stone...

Spanjaard
classic indeed, i have a very similar project inventory, so really interested in the issues you may find 😉

Stephen Lesley
The issues I found were with the lower hull and the rear panel. These have to be carefully lined up or it can affect the fit with the upper hull. The turret was slightly warped which affected the fit with the turret ring and how it sits on top of the hull. The most annoying issue so far is the fitting of the side skirt brackets to the frame and the frame to the hull. The sprue gates for the brackets are on the mating surface so if you don't file them perfectly flat, they are out of line. And in a complete brain fart on behalf of Tamiya they designed the kit in such a way that if you attach all the tool racks etc on the the right hand side of the hull using the mounting holes, it prevents you attaching the side skirt frame properly, because the tools end up too low on the hull side. In the end I had to break off the jack block and some of the tool clamps to make the frame fit on the side. Not happy!

Spanjaard
thanks for all the info!

Sergej I
Crazy details, man! 👍 Hows the fit?

Cole
It's not too bad, but when I enclose the interior, there is a need for quite a bit of trimming. I also need to add extra material to the top and bottom of the interior so the airframe sits flat at the bottom and marries up equally at the top. I'll add more photos when I'm up to that stage

István Szücs
Watching!