Новостная лента
Thomas E.
добавил новый фотоальбом.
добавил новый фотоальбом.
28 изображения
The fire station (Ste.-Marie-sur-Mer 5)Новый: 13 September, 13:51 1:35
Building the fire department siren - using ferrules.
12 22 August, 09:54
Thomas E.
Thank you for comment and likes. The work is going on ... stay tuned, please.
Thank you for comment and likes. The work is going on ... stay tuned, please.
2 September, 04:20
Thomas E.
I'm dreaming about a Citroën C4 "Pompier" in 1:35. Heller had made this car in 1:24 already. Maybe the new location in Radevormwald will be an inspiration. ... dreamin' ...
I'm dreaming about a Citroën C4 "Pompier" in 1:35. Heller had made this car in 1:24 already. Maybe the new location in Radevormwald will be an inspiration. ... dreamin' ...
2 September, 04:31
Todd Bassett
начал
начал
Death Star II & Star Destroyer Scale 1:2,700,000
Bandai 1:2700k
0230358 (01207) 2018 Модельный набор Несколько моделей (2)13 September, 13:50
Nathan Dempsey
добавил новый фотоальбом.
добавил новый фотоальбом.
6 изображения
F8F-1B Bearcat - Indochina WarНовый: 13 September, 13:50 1:48
Yellow Zinc Chromate for the wheel wel
Проект: F8F-1B Bearcat - Indochina War
3 8 September, 00:57
Nathan Dempsey
Welcome Ben!
Work has started. Drilled holes in the lower wing for hardpoints and centerline fuel tank. Cockpit is nearly complete with photos soon since it will be nearly invisible once installed.
Welcome Ben!
Work has started. Drilled holes in the lower wing for hardpoints and centerline fuel tank. Cockpit is nearly complete with photos soon since it will be nearly invisible once installed.
12 September, 14:47
Greg Baker
добавил новый фотоальбом.
добавил новый фотоальбом.
32 18 April, 05:15
Greg Baker
This one is likely to be a quick little build. It's basically the companion piece to the Puss Moth, so I felt like I couldn't really build one without the other. Erik is right though, the kit is of an impressive vintage. It is indeed a few years older than I am, and has the flash to prove it. 🙂
Anyway, thanks for joining, there's plenty of seats available, so no shoving. 😉
This one is likely to be a quick little build. It's basically the companion piece to the Puss Moth, so I felt like I couldn't really build one without the other. Erik is right though, the kit is of an impressive vintage. It is indeed a few years older than I am, and has the flash to prove it. 🙂
Anyway, thanks for joining, there's plenty of seats available, so no shoving. 😉
18 April, 14:01
Greg Baker
You say that now... but wait till you see how much putty and sanding is required~
You say that now... but wait till you see how much putty and sanding is required~
6 May, 19:05
Greg Baker
Well, it's supposed to be a Hawker Hart apparently... but the Hawker Demon is close enough... I mean, it's not like it's a Spitfire. 😉
Well, it's supposed to be a Hawker Hart apparently... but the Hawker Demon is close enough... I mean, it's not like it's a Spitfire. 😉
6 May, 23:10
Alex K
Good enough for me - I'm arguably one of the least rivet-counting persons in here... just asking/checking... 😉
Good enough for me - I'm arguably one of the least rivet-counting persons in here... just asking/checking... 😉
6 May, 23:25
Matthew A
And only a masochist with ADHD would consider trying to convert it back to a Hart like the original 1957 tool... 🤪
And only a masochist with ADHD would consider trying to convert it back to a Hart like the original 1957 tool... 🤪
7 May, 16:18
Greg Baker
What did you call me? 😉
I mean, besides the dip between the two cockpits... are there any other differences? They look quite similar to me...
What did you call me? 😉
I mean, besides the dip between the two cockpits... are there any other differences? They look quite similar to me...
7 May, 17:57
Alex K
Well, the "dip between the two cockpits" is the main difference I was referring to above... Plus, you'll have to skip the Demon's long exhausts, I guess...
Well, the "dip between the two cockpits" is the main difference I was referring to above... Plus, you'll have to skip the Demon's long exhausts, I guess...
7 May, 18:25
Greg Baker
Not exactly sure what picture to take to update my progress… I'm working on bits of everything all at once!
Not exactly sure what picture to take to update my progress… I'm working on bits of everything all at once!
10 May, 05:52
Matthew A
The main difference between a Demon and a Hart is the exhausts, the turret and the starboard machine gun. Will send a PM
The main difference between a Demon and a Hart is the exhausts, the turret and the starboard machine gun. Will send a PM
16 May, 16:53
Alex K
IF however (regardless of how a real Hart should be) what is shown in the comic ("That's what I call" etc frame) is indeed a starboard mg (please correct me if I'm wrong...) then starting with a Demon kit was perhaps indeed a better idea than starting with a Hart kit.... IF this is the case... then you'll only have to deal with the rear seat/turret thing and the free (ala Fury) exhausts, no?
IF however (regardless of how a real Hart should be) what is shown in the comic ("That's what I call" etc frame) is indeed a starboard mg (please correct me if I'm wrong...) then starting with a Demon kit was perhaps indeed a better idea than starting with a Hart kit.... IF this is the case... then you'll only have to deal with the rear seat/turret thing and the free (ala Fury) exhausts, no?
16 May, 19:43
Greg Baker
Yeah. I think so. Matthew provided some detailed comparison images but after looking at them and at the main page from the album... it seems to be a little bit of both...
Yeah. I think so. Matthew provided some detailed comparison images but after looking at them and at the main page from the album... it seems to be a little bit of both...
16 May, 22:09
Matthew A
In Tintin in the Land of the Black Gold it could be a Hawker Hardy
i.imgur.com/57c2RcA.jpeg
In Tintin in the Land of the Black Gold it could be a Hawker Hardy
i.imgur.com/57c2RcA.jpeg
23 May, 21:51
Greg Baker
A couple of updates. The supports next to the fuselage were so weak that 3/4 of them snapped even before I got them off the sprue. So instead I just used some bent wire. The holes they are meant to slot into were gaping caverns as well, so a fair amount of putty was needed to make it at least slightly better. Now I'm left with a decision to make. The Hawker Demon has two large exhaust tubes that run from the engine down the sides. They're not present in the Tintin album (which most closely resembles a Hawker Heart I believe). So... do I leave the two side holes and the large trenches on either side of the engine cowling, or do I just shrug my shoulders and use the parts that came in the box?
The Blue Rider decals went on easily enough. They're a bit shiny, but I think I can deal with that.
A couple of updates. The supports next to the fuselage were so weak that 3/4 of them snapped even before I got them off the sprue. So instead I just used some bent wire. The holes they are meant to slot into were gaping caverns as well, so a fair amount of putty was needed to make it at least slightly better. Now I'm left with a decision to make. The Hawker Demon has two large exhaust tubes that run from the engine down the sides. They're not present in the Tintin album (which most closely resembles a Hawker Heart I believe). So... do I leave the two side holes and the large trenches on either side of the engine cowling, or do I just shrug my shoulders and use the parts that came in the box?
The Blue Rider decals went on easily enough. They're a bit shiny, but I think I can deal with that.
11 September, 15:38
Greg Baker
Thanks Matthew. I'm quite pleased with how the colouring came out too. A 2:1 ratio of Tamiya Buff (XF-57) and Khaki (XF-49) seems to have done the trick... or at least close enough for me.
Thanks Matthew. I'm quite pleased with how the colouring came out too. A 2:1 ratio of Tamiya Buff (XF-57) and Khaki (XF-49) seems to have done the trick... or at least close enough for me.
11 September, 15:58
Greg Baker
I just noticed the artwork has actual rigging on it, so it looks like I'm not quite as done as I thought. Besides that, only a few nice white fluffy clouds needed for the base.
I just noticed the artwork has actual rigging on it, so it looks like I'm not quite as done as I thought. Besides that, only a few nice white fluffy clouds needed for the base.
13 September, 13:50
Mauricio Rada Matamoros
добавил новый фотоальбом.
добавил новый фотоальбом.
2 изображения
(3°) Panavia Tornado Gr.Mk.I1:144
Fue mi 3° kit construido por el año 2000 aproximadamente; la pintura no son las que venden para modelismo, sino las de b...
Проект: Panavia Tornado Gr.Mk.I
4 11 September, 21:12
Spanjaard
ya me hubiera gustado que alguno de mis primeros models hubiera estado pintado como esté, yo usaba la pintura como masilla para tapar huecos 😄 😄
ya me hubiera gustado que alguno de mis primeros models hubiera estado pintado como esté, yo usaba la pintura como masilla para tapar huecos 😄 😄
13 September, 13:17
Mauricio Rada Matamoros
Jejeje... yo ni me percataba de sellar uniones o raspar ranuras en los primeros.
Jejeje... yo ni me percataba de sellar uniones o raspar ranuras en los primeros.
13 September, 13:45
Pitonuss
хочет
хочет
Steregushchiy-class corvette
FFG Project 20380 Early Production Takom 1:350
6012 2024* Новая разработка 13 September, 13:44
NitrousRocket
добавил новый фотоальбом.
добавил новый фотоальбом.
7 изображения
MyAlbumНовый: 13 September, 07:38 Thunder Models Bergepanzer Hetzer with Tamiya maintenance crew and Miniart Maybach HL120 engine an
3 13 September, 07:37
Christoph Kunz
Pretty cool for your first one. 👍
I like that toolbox, can you tell from which company it is?
Pretty cool for your first one. 👍
I like that toolbox, can you tell from which company it is?
13 September, 10:00
Rick402
владеет этим предметом
владеет этим предметом
Japanese Type95 Light Tank early version (Gun barrel Include) Dragon 6767
Voyager Model 1:35
PE 35567 2013 Новая разработка 13 September, 13:40
Oleg Bogolei
добавил новый фотоальбом.
добавил новый фотоальбом.
5 13 September, 13:12
Sergej I
Great Phantom, excellent touch up with the PE details 👍. Also noticed correctly-missing front Sparrows 🙂
Great Phantom, excellent touch up with the PE details 👍. Also noticed correctly-missing front Sparrows 🙂
13 September, 13:37
Jaroslaw Zbieg
добавил новый фотоальбом.
добавил новый фотоальбом.
3 10 September, 14:41
Jaroslaw Zbieg
It's a 15 year old Academy kit so no big issiues, bit of filler here and there. Resin parts fitment is Ok.
It's a 15 year old Academy kit so no big issiues, bit of filler here and there. Resin parts fitment is Ok.
13 September, 13:36
/ru/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=ru
35
35
/ru/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo