Новостная лента
Aleksandrs P
хочет
хочет
German
88mm Gun Flak 36 w/SSys Wagon Border Model 1:35
BT-044 2024 Новые детали Несколько моделей (1!!)13 September, 06:55
Roger Trewenack
добавил новый фотоальбом.
добавил новый фотоальбом.
101 изображения
Eaglemoss BTTF De LoreanНовый: 13 September, 06:48 1:8
More fine wiring on the RHS of the engine bay "shelf". - later used a dab of hot glue to tuck those wires in properley
Проект: BTTF De Lorean
14 2 August, 02:50
Roger Trewenack
the window are manually lifted, sorry - you lift up the gull-wing door, and that reveals the bottom cog which you can wind with your finger
the window are manually lifted, sorry - you lift up the gull-wing door, and that reveals the bottom cog which you can wind with your finger
9 September, 09:23
RichardF
добавил новый фотоальбом.
добавил новый фотоальбом.
16 12 September, 15:38
Mr James
Oh yes indeed. Lovely mottling spray job and great scratches and wear around the frame.
Oh yes indeed. Lovely mottling spray job and great scratches and wear around the frame.
12 September, 17:38
Gary Victory
Very nice build and paint work Richard. Love the mottling. Top job Sir.
Very nice build and paint work Richard. Love the mottling. Top job Sir.
13 September, 06:47
Greg Baker
добавил новый фотоальбом.
добавил новый фотоальбом.
32 18 April, 05:15
Greg Baker
This one is likely to be a quick little build. It's basically the companion piece to the Puss Moth, so I felt like I couldn't really build one without the other. Erik is right though, the kit is of an impressive vintage. It is indeed a few years older than I am, and has the flash to prove it. 🙂
Anyway, thanks for joining, there's plenty of seats available, so no shoving. 😉
This one is likely to be a quick little build. It's basically the companion piece to the Puss Moth, so I felt like I couldn't really build one without the other. Erik is right though, the kit is of an impressive vintage. It is indeed a few years older than I am, and has the flash to prove it. 🙂
Anyway, thanks for joining, there's plenty of seats available, so no shoving. 😉
18 April, 14:01
Greg Baker
You say that now... but wait till you see how much putty and sanding is required~
You say that now... but wait till you see how much putty and sanding is required~
6 May, 19:05
Greg Baker
Well, it's supposed to be a Hawker Hart apparently... but the Hawker Demon is close enough... I mean, it's not like it's a Spitfire. 😉
Well, it's supposed to be a Hawker Hart apparently... but the Hawker Demon is close enough... I mean, it's not like it's a Spitfire. 😉
6 May, 23:10
Alex K
Good enough for me - I'm arguably one of the least rivet-counting persons in here... just asking/checking... 😉
Good enough for me - I'm arguably one of the least rivet-counting persons in here... just asking/checking... 😉
6 May, 23:25
Matthew A
And only a masochist with ADHD would consider trying to convert it back to a Hart like the original 1957 tool... 🤪
And only a masochist with ADHD would consider trying to convert it back to a Hart like the original 1957 tool... 🤪
7 May, 16:18
Greg Baker
What did you call me? 😉
I mean, besides the dip between the two cockpits... are there any other differences? They look quite similar to me...
What did you call me? 😉
I mean, besides the dip between the two cockpits... are there any other differences? They look quite similar to me...
7 May, 17:57
Alex K
Well, the "dip between the two cockpits" is the main difference I was referring to above... Plus, you'll have to skip the Demon's long exhausts, I guess...
Well, the "dip between the two cockpits" is the main difference I was referring to above... Plus, you'll have to skip the Demon's long exhausts, I guess...
7 May, 18:25
Greg Baker
Not exactly sure what picture to take to update my progress… I'm working on bits of everything all at once!
Not exactly sure what picture to take to update my progress… I'm working on bits of everything all at once!
10 May, 05:52
Matthew A
The main difference between a Demon and a Hart is the exhausts, the turret and the starboard machine gun. Will send a PM
The main difference between a Demon and a Hart is the exhausts, the turret and the starboard machine gun. Will send a PM
16 May, 16:53
Alex K
IF however (regardless of how a real Hart should be) what is shown in the comic ("That's what I call" etc frame) is indeed a starboard mg (please correct me if I'm wrong...) then starting with a Demon kit was perhaps indeed a better idea than starting with a Hart kit.... IF this is the case... then you'll only have to deal with the rear seat/turret thing and the free (ala Fury) exhausts, no?
IF however (regardless of how a real Hart should be) what is shown in the comic ("That's what I call" etc frame) is indeed a starboard mg (please correct me if I'm wrong...) then starting with a Demon kit was perhaps indeed a better idea than starting with a Hart kit.... IF this is the case... then you'll only have to deal with the rear seat/turret thing and the free (ala Fury) exhausts, no?
16 May, 19:43
Greg Baker
Yeah. I think so. Matthew provided some detailed comparison images but after looking at them and at the main page from the album... it seems to be a little bit of both...
Yeah. I think so. Matthew provided some detailed comparison images but after looking at them and at the main page from the album... it seems to be a little bit of both...
16 May, 22:09
Matthew A
In Tintin in the Land of the Black Gold it could be a Hawker Hardy
i.imgur.com/57c2RcA.jpeg
In Tintin in the Land of the Black Gold it could be a Hawker Hardy
i.imgur.com/57c2RcA.jpeg
23 May, 21:51
Greg Baker
A couple of updates. The supports next to the fuselage were so weak that 3/4 of them snapped even before I got them off the sprue. So instead I just used some bent wire. The holes they are meant to slot into were gaping caverns as well, so a fair amount of putty was needed to make it at least slightly better. Now I'm left with a decision to make. The Hawker Demon has two large exhaust tubes that run from the engine down the sides. They're not present in the Tintin album (which most closely resembles a Hawker Heart I believe). So... do I leave the two side holes and the large trenches on either side of the engine cowling, or do I just shrug my shoulders and use the parts that came in the box?
The Blue Rider decals went on easily enough. They're a bit shiny, but I think I can deal with that.
A couple of updates. The supports next to the fuselage were so weak that 3/4 of them snapped even before I got them off the sprue. So instead I just used some bent wire. The holes they are meant to slot into were gaping caverns as well, so a fair amount of putty was needed to make it at least slightly better. Now I'm left with a decision to make. The Hawker Demon has two large exhaust tubes that run from the engine down the sides. They're not present in the Tintin album (which most closely resembles a Hawker Heart I believe). So... do I leave the two side holes and the large trenches on either side of the engine cowling, or do I just shrug my shoulders and use the parts that came in the box?
The Blue Rider decals went on easily enough. They're a bit shiny, but I think I can deal with that.
11 September, 15:38
Greg Baker
Thanks Matthew. I'm quite pleased with how the colouring came out too. A 2:1 ratio of Tamiya Buff (XF-57) and Khaki (XF-49) seems to have done the trick... or at least close enough for me.
Thanks Matthew. I'm quite pleased with how the colouring came out too. A 2:1 ratio of Tamiya Buff (XF-57) and Khaki (XF-49) seems to have done the trick... or at least close enough for me.
11 September, 15:58
M0rce
добавил новый фотоальбом.
добавил новый фотоальбом.
26 22 August, 23:59
M0rce
Hi all.
I have a video about my progress on this kit on YouTube of you are interested.
Youtube Video
Thanks
Hi all.
I have a video about my progress on this kit on YouTube of you are interested.
Youtube Video
Thanks
23 August, 00:06
M0rce
Hi nikfrost.
Just 1, Ross Jackal.
But as I have deviated on the colour scheme, I may make one up. Hoping to find some rub on letters at the hobby shop.
Any name suggestions? (Question open to all of course 🙂 )
Have a good day.
Hi nikfrost.
Just 1, Ross Jackal.
But as I have deviated on the colour scheme, I may make one up. Hoping to find some rub on letters at the hobby shop.
Any name suggestions? (Question open to all of course 🙂 )
Have a good day.
24 August, 10:14
nikfrost
Thanks M0rce. I live near the Humber Estuary which is connected to the North Sea, my suggestion would be Mud Shark haha.
Thanks M0rce. I live near the Humber Estuary which is connected to the North Sea, my suggestion would be Mud Shark haha.
24 August, 14:13
M0rce
Hi everybody,
Thanks for your comments and ship name suggestions
I didn't manage to find any rub on letters at the hobbyshop, but got a few sheets of single.letter decals...
Not sure haw that's going to work. Got to.pravtice that a bit before I attempt on the model.
Keep ship name suggestions coming.
Hi everybody,
Thanks for your comments and ship name suggestions
I didn't manage to find any rub on letters at the hobbyshop, but got a few sheets of single.letter decals...
Not sure haw that's going to work. Got to.pravtice that a bit before I attempt on the model.
Keep ship name suggestions coming.
24 August, 20:52
M0rce
Hi everybody,.
New update video on youtube.
Youtube Video
You input would be apprecisted.
Hi everybody,.
New update video on youtube.
Youtube Video
You input would be apprecisted.
25 August, 20:03
M0rce
Erm.... just found this build yesterday... I need to up my game on this build.
modellversium.de/gal..s-cougar-revell.html
Erm.... just found this build yesterday... I need to up my game on this build.
modellversium.de/gal..s-cougar-revell.html
26 August, 09:37
M0rce
Hi Tcamp.
Are you my youtube buddy?
Show your work.pleaee, I'd love to see it. 😀
Hi Tcamp.
Are you my youtube buddy?
Show your work.pleaee, I'd love to see it. 😀
11 September, 08:24
Ian Robinson
добавил новый фотоальбом.
добавил новый фотоальбом.
5 12 September, 23:28
Gary Victory
Now that's a blast from the past..!! I Remember building this back in the 80's.... I hope you enjoyed building this Ian. Nice work.
Now that's a blast from the past..!! I Remember building this back in the 80's.... I hope you enjoyed building this Ian. Nice work.
13 September, 06:43
Thomas Neuss@Steffen
Hallo,
sind die Mosquito Control Surfaces und Flame Dampening Exhaust Shrouds noch verfügbar und zu verkaufen?
Viele Grüße
Thomas
Hallo,
sind die Mosquito Control Surfaces und Flame Dampening Exhaust Shrouds noch verfügbar und zu verkaufen?
Viele Grüße
Thomas
9 September, 19:46
Steffen
Hallo Thomas, ja, die sind noch da!
Hättest du sonst noch an etwas aus meinem Stash Interesse?
Gruß, Steffen
Hallo Thomas, ja, die sind noch da!
Hättest du sonst noch an etwas aus meinem Stash Interesse?
Gruß, Steffen
11 September, 21:00
Thomas Neuss
Hi - die beiden Sachen sind dann alles. Ich komme mir selber etwas dämlich vor, dass ich das übersehen habe, als ich die Mosquito angefragt habe... seufz. Jetzt bin ich alles durchgegangen. Viele Grüße, Thomas
Hi - die beiden Sachen sind dann alles. Ich komme mir selber etwas dämlich vor, dass ich das übersehen habe, als ich die Mosquito angefragt habe... seufz. Jetzt bin ich alles durchgegangen. Viele Grüße, Thomas
12 September, 05:04
Steffen
Hi Thomas, damit ich das Porto bestimmen kann, muss ich wissen, wo du wohnst. Wäre PayPal ok? Gruß, Steffen
Hi Thomas, damit ich das Porto bestimmen kann, muss ich wissen, wo du wohnst. Wäre PayPal ok? Gruß, Steffen
12 September, 21:26
Thomas Neuss
Hallo,
der Versand wäre in Deutschland, hier schon mal meine Adresse:
Thomas Neuss
Wilhelm-Leuschner-Weg 5
25524 Itzehoe
PayPal (Freunde) ist völlig ok für mich.
Viele gRüße
Thomas
Hallo,
der Versand wäre in Deutschland, hier schon mal meine Adresse:
Thomas Neuss
Wilhelm-Leuschner-Weg 5
25524 Itzehoe
PayPal (Freunde) ist völlig ok für mich.
Viele gRüße
Thomas
13 September, 06:43
André Knippenberg
добавил новый фотоальбом.
добавил новый фотоальбом.
13 September, 06:41
Nous
хочет
хочет
Panzerkampfwagen IV Ausf G. Early Production & Motorcycle Eastern Front
Tamiya 1:35
25209 2023 Новые детали 13 September, 06:42
/ru/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=ru
35
35
/ru/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo