Vaught F4U-1D Corsair ( Tamiya 1/72) Combat Worn Heavy Weathered

1
August 12, 2024
Seat and controls painted and assembled. PE parts from Eduard set.
2
August 12, 2024
Instrument panel and rudder controls assembled and painted.
3
August 12, 2024
Landing gear already assembled and detailed with PE parts. Quite the challenge working with something this small
4
August 13, 2024
Interiors painted and weathered. Don't know why the green Is so bright in the picture, it isn't that colourfully and much more matte in reality
5
August 13, 2024
6
August 13, 2024
Cockpit and fuselage half's assembled. The fit unsurprisingly was almost perfect, probably no putty will be needed
7
August 13, 2024
Some pictures inside the cockpit now assembled
8
August 13, 2024
Some pictures inside the cockpit now assembled
9
August 13, 2024
Some pictures inside the cockpit now assembled
10
August 15, 2024
Wheel wells finished. A little bit disappointed with this ugly ejector pin marks, I didn't see them at first but hoping to be masked out by the landing gear once in place
11
August 15, 2024
Fully assembled and painted. The fit between the wings and the fuselage, as the fuselage itself, was perfect.
12
August 19, 2024
13
August 19, 2024
Little peak of the engine, before putting PE spark plug lines
14
August 20, 2024
Engine already mounted!! Final step before priming and painting the
15
August 20, 2024
Removed and drilled some of the lights that came raised above the wing surface or built in to try and paint them later on. Hoping to achieve better looking lights with this small modification
16
August 20, 2024
Also carved out the exhaust pipes on the bottom. They came completely blocked and didn't liked how they looked
17
August 20, 2024
I'm going to weather this model by applying a three layer effect. First primed with black followed by a metal color. Then I'll continue with the same interior green I've been using in all the build to act as the real life primer. Finally I'll add another layer of black primer to unify everything and apply some shadows before applying the final blue color.
18
August 20, 2024
For the chipping effect I've added a layer of hairspray between both paints I want to chip. One after the metal and another one after the green primer
19
August 21, 2024
Preshading already in place
20
August 21, 2024
Started with some heavy chipping on the wings and fuselage of the Corsair. Looking good so far even though a small amount of blending is going to be needed to better see some results. The green primer I used it's barely visible if visible at all. My main guess Is that used to little of it and it's being completely removed with the chipping
21
September 2, 2024
Half of the weathering done as I finished the chipping process. I also added the decals and chipped them in the zone where maintenance and pilot would be walking and moving around. I
22
September 2, 2024
23
September 2, 2024
24
September 2, 2024
The underside of the plane was chipped too, although way lees because I wanted to achieve chipping as a result of a worked on plane by maintenance crew and pilot.
25
September 2, 2024
Propeller done. I wanted to simulate some erosion here. Due to scale, lighting and camera, in this picture it looks much accentuated than it really is. In reality it much more blended and the
26
September 3, 2024
I only included one of the PE parts available for the drop tanks. In the end, this part is secondary, and the details are so small they were going to be of little use. Loving the end result with the chipping and added dirt.
27
September 3, 2024
Main landing gear assembly, it looks perfect in my opinion, just the finish I wanted to achieve. With the added detail by the PE parts, the assembly looks amazing
28
September 3, 2024
Tail landing gear also done. Wanted to add the stripes just too add a little bit more profundity to the hook.
29
September 4, 2024
Guns and exhaust smoke effects made with pastels. There's a lot of technics to achieve this result, but for me, this is the most realistic and easiest to work with. I use some black for the base, and then is add some grey/tan color to achieve that smokey look. Better to use a lot because when applying varnish it will difuminate a bit
30
September 4, 2024
The holes I made inf the exhaust look fantastic. I'm so glad I went that way with it.
31
September 4, 2024
32
September 4, 2024
33
September 4, 2024
34
September 4, 2024
Almost done. Apart from the rigging and the missiles. Ive loved this built. It was so much fun. I also like the result a lot. This heavy weather finish i think turned out fantastic.
35
September 4, 2024
36
September 4, 2024
37
September 4, 2024
38
September 4, 2024
39
September 4, 2024
You will probably notice the absence of the gunsight, unfortunatley, i lost the piece to the floor void. Never to be seen again i guees
40
September 4, 2024
41
September 4, 2024
42
September 4, 2024
43
September 4, 2024
44
September 4, 2024
45
September 4, 2024
46
September 4, 2024
47
September 8, 2024
Wire antennas added with rigging line. Turnbuckles kind of simulated with a little bit of ova glue and white
48
September 8, 2024
49
September 8, 2024
Pitot and nav lights done. The light were done with a first layer of aluminum for the reflective part, a transparent color, and a tips leyer of UV resin to simulate the lens.
50
September 8, 2024
Formation lights added with the same method as the nav lights.
51
September 8, 2024
Landing light made with UV resin too

Miguel Vaquero
I use cyanoacrylate for the PE parts, just a little amount sticks okay, although at this scale there's some parts that are way to hard to make them stick and my not so skilled application of the glue leaves a lot of residue on the model. I try to clean up the best I can but it's quite challenging sometimes

If you want to build a good looking cockpit with the extra detail I recommend you the PE for sure. But if your main goal is the exterior and not to focus so much on the interior the PE kit doesn't include a lot of things for the exterior, and the tamiya kit I think gives a really nice looking base cockpit

20 August, 19:57

Miguel Vaquero
With half the plane chipped, I'm leaving for the week. There's still a lot of work to do regarding chipping and weathering to blend the paints. I'm having so much fun, and applying new technics for me that I'm sure I'll use in future models.

21 August, 12:32

Mr D
Thanks Miguel 😃👍
I've only been building again as an adult for just over a year, so the advice helps me improve.
And as l said will probably be my next build.
Good luck with everything Miguel.. enjoy 👍👍👍

21 August, 16:05

Miguel Vaquero
Chipping and decals done. I'm sure this chipping is not going to be of the liking of many, but I wanted to try different techniques and achieve a heavy worked on plane who could not get a paint job in a lot of time. I really like the result I achieved, even though it may seem extreme, I think it adds a lot of personality to the model, and also adds some history to it. Let me know your opinions on this and what would you have done differently with this chipping process

2 September, 11:12

Mr D
It fine, I've seen much heavier worked model than this..?
In reality they looked beat up from war n work... Especially the Corsair.
Best to build a model to how you like it.
I put all my models on a stand with wheels down , some people will cringe at that.🤣 But l like it personally, as l see more of the work I've done.
I'm yet to start wearing.... As quiet new to the game and learnt.
I think you done nice job, well done 👌 👍👍👍

2 September, 15:37

Miguel Vaquero
Thanks Mr D. I'm with you in this one. The best thing about this hobby is to do things as one likes. At the end of the day, the one who's going to be looking at them is us 😁😁

2 September, 17:37

Miguel Vaquero
Weathering done!! I will leave the rockets for the last, that means, next step FULL ASSEMBLY

4 September, 12:11

Miguel Vaquero
Final assembly done. Only thing left are the missiles and the wire antennas. Once I have all completed I'll try to make some better pictures

4 September, 19:34

Mr D
Coming along nicely 👌👍👍🖌️

4 September, 19:57

Miguel Vaquero
Antennas and lights DONE!!

8 September, 17:23

Guy Rump
Great job, congrats! 👍

8 September, 17:28

Miguel Vaquero
Thanks guys!

8 September, 17:55

Mr D
Very nice, well done Miguel 👌 Nice Corsair to your collection... been good to watch project 👍👍

8 September, 19:21

Miguel Vaquero
Thanks MrD glad you enjoyed it 😊

8 September, 20:59

Nicolas
Looks great, congrats.

9 September, 17:44

Miguel Vaquero
Thank you Nicolas!!

9 September, 18:42

Album info

First time trying chipping in this 1/72 wonderfull kit from Tamiya. My goal is to obteain a heavy weather piece, showing its time of war and maintenance

Vought F4U-1D Corsair

51 изображения

1:72

Завершённые

Vought F4U-1D Corsair

US Navy (1794-now)
VF-84 167
Февраль 1945 - USS Bunker Hill (CV-17)

Все альбомы

Посмотреть все альбомы »

Vaught F4U-1D Corsair ( Tamiya 1/72) Combat Worn Heavy Weathered

Комментарии

Album info

Vought F4U-1D Corsair

Все альбомы