WIP - Tunguska/Tor Complex
Комментарии
5 13 February 2020, 18:31
Przemek Przybulewski
Started some time ago but it is hard to build it in one go.
Plastic is not too good - hard and tends to crack. A lot of seam lines. Myriads of small parts. Unclear instructions.
Will build it in the meantime of Su-25 and Faun.
Hard to clean all those tiny parts parts that see very well on this green plastic.
Most likely will be a lot to correct after spraying primer.
Started some time ago but it is hard to build it in one go.
Plastic is not too good - hard and tends to crack. A lot of seam lines. Myriads of small parts. Unclear instructions.
Will build it in the meantime of Su-25 and Faun.
Hard to clean all those tiny parts parts that see very well on this green plastic.
Most likely will be a lot to correct after spraying primer.
13 February 2020, 18:35
Treehugger
It could be helpful cleaning the small parts when they are still on the sprue.
It could be helpful cleaning the small parts when they are still on the sprue.
13 February 2020, 18:44
Przemek Przybulewski
Yeah, I tried this as well. I helps sometimes, but usually small parts are attached with tiny sprue pin. One bad move and they fly away like a sling shot 😉
Yeah, I tried this as well. I helps sometimes, but usually small parts are attached with tiny sprue pin. One bad move and they fly away like a sling shot 😉
13 February 2020, 18:52