Стена
Wall
Steven Van Dyck
добавил новый фотоальбом.
добавил новый фотоальбом.
All comments (67) » 52 19 June 2023, 19:38
Steven Van Dyck
Thanks Gorby! Now both decks are applied, some setbacks needed to be resolved. In both ships the deck edge elevator was not fitting between the PE constructions to the outside of the hull. I should have corrected this before painting all. I did succeed in removing and reattaching the PE without all too much paint and PE damage, it might not be visible after the repair job. Hancock got the elevator level with the hangar deck and Essex got it stowed in vertical position. This is only possible with retracted safety netting, so that too was moved. I also made a schematic walkthrough showing how I needed to remove the front internal hangar bulkhead of the Hancock model, that seemed to have some badly fitting extra parts to the Essex original sprues. This didn't sit flush with the front elevator edge, so the wooden floor wouldn't fit below the well. It seemed impossible to resolve without opening up the front deck part, but there was another option. I sawed a large hole in the bottom plate and milled through a support plate and the extended hangar floor to be able to push the bulkhead out of the hangar. I then fixed it flush with the well and puttied the floor taht was left a bit mangled by the milling tool. A large part of this will be covered by the wooden floor.
Thanks Gorby! Now both decks are applied, some setbacks needed to be resolved. In both ships the deck edge elevator was not fitting between the PE constructions to the outside of the hull. I should have corrected this before painting all. I did succeed in removing and reattaching the PE without all too much paint and PE damage, it might not be visible after the repair job. Hancock got the elevator level with the hangar deck and Essex got it stowed in vertical position. This is only possible with retracted safety netting, so that too was moved. I also made a schematic walkthrough showing how I needed to remove the front internal hangar bulkhead of the Hancock model, that seemed to have some badly fitting extra parts to the Essex original sprues. This didn't sit flush with the front elevator edge, so the wooden floor wouldn't fit below the well. It seemed impossible to resolve without opening up the front deck part, but there was another option. I sawed a large hole in the bottom plate and milled through a support plate and the extended hangar floor to be able to push the bulkhead out of the hangar. I then fixed it flush with the well and puttied the floor taht was left a bit mangled by the milling tool. A large part of this will be covered by the wooden floor.
24 August, 22:32
Steven Van Dyck
The deck PE particles are pre-painted after being primered grey. Even with this primer they scratch easily. The wooden decks of Hancock and in larger measures Essex must be cut out where the PE parts come. Some of these aren't even pre-cut and must be traced form the parts, like the barriers. I know that laser lines must not overlap, so they wanted to avoid drawing the near-vertical lines over the planking. Because of that, it's better to do the barriers first and then the expansion joints. The gutters around the deck are added with Hancock and will now be completed on Essex.
The deck PE particles are pre-painted after being primered grey. Even with this primer they scratch easily. The wooden decks of Hancock and in larger measures Essex must be cut out where the PE parts come. Some of these aren't even pre-cut and must be traced form the parts, like the barriers. I know that laser lines must not overlap, so they wanted to avoid drawing the near-vertical lines over the planking. Because of that, it's better to do the barriers first and then the expansion joints. The gutters around the deck are added with Hancock and will now be completed on Essex.
28 August, 01:01
August 25, 2024
August 21, 2024
August 17, 2024
August 10, 2024
Steven Van Dyck
владеет этим предметом
владеет этим предметом
AH-64 Apache M230 chain gun barrel (30mm), pitot tubes & tail antenna
Master 1:72
AM-72-109 2016 Новая разработка 10 August, 08:08
Steven Van Dyck
владеет этим предметом
владеет этим предметом
Paint Mask for MT-LB (clear parts & wheels) Trumpeter
KAV models 1:35
KAV M35 062 2017 Новая разработка 10 August, 08:08
August 8, 2024
August 7, 2024
August 6, 2024
Steven Van Dyck
пометил этот товар как заказанный
пометил этот товар как заказанный
Paint Mask for MT-LB (clear parts & wheels) Trumpeter
KAV models 1:35
KAV M35 062 2017 Новая разработка 6 August, 14:28
Steven Van Dyck
пометил этот товар как заказанный
пометил этот товар как заказанный
AH-64 Apache M230 chain gun barrel (30mm), pitot tubes & tail antenna
Master 1:72
AM-72-109 2016 Новая разработка 6 August, 14:27
August 5, 2024
August 1, 2024
Steven Van Dyck
владеет этим предметом
владеет этим предметом
World Architecture Series
The Parthenon Athenian Acropolis 348 b.c. Italeri 1:100
68001 2015 Новая разработка 1 August, 14:38
Steven Van Dyck
владеет этим предметом
владеет этим предметом
M3 Half-track Sagged front wheel set (1) For AFV, Dragon M2/M3/M16
Def.Model 1:35
DW30050 2020 Новая разработка Несколько моделей (1!!)1 August, 01:15
July 31, 2024
July 25, 2024
Steven Van Dyck
пометил этот товар как заказанный
пометил этот товар как заказанный
M3 Half-track Sagged front wheel set (1) For AFV, Dragon M2/M3/M16
Def.Model 1:35
DW30050 2020 Новая разработка Несколько моделей (1!!)25 July, 21:14
Steven Van Dyck
владеет этим предметом
владеет этим предметом
German 75mm gun barrel for PaK40 with late muzzle brake
Aber 1:72
72L56 (72L-56) 2012 Новая разработка 25 July, 09:07
Steven Van Dyck
владеет этим предметом
владеет этим предметом
Road Wheels for FlaK/Nebelwerfer Trailers (Commercial Pattern A)
Panzer Art 1:35
RE35-208 25 July, 09:07
July 22, 2024
Steven Van Dyck
владеет этим предметом
владеет этим предметом
WWII USN
USS Massachusetts BB-59 1945 - Complete Upgrade Set for Trumpeter 05306 Five Star Model 1:350
FS350048 2017 22 July, 11:36
July 20, 2024
July 15, 2024
Steven Van Dyck
добавил новый фотоальбом.
добавил новый фотоальбом.
All comments (12) » 13 12 August 2023, 00:03
Steven Van Dyck
The pVoyager photo etch cabin roof is constructed with all its nightmarish embossing deformities corrected, the badly fitting airco module that was mosly bent the wrong way around so it broke at one instance. I replaced the 3 largest clearparts with a piece of Trumpeter 1/350 airplane set transparent box cover, that has the right thickness to be able to sand the corner roundings in it. The air purifier system is not installed completely, because that would impede the clearpart masking. So now it's down to interior painting.
The pVoyager photo etch cabin roof is constructed with all its nightmarish embossing deformities corrected, the badly fitting airco module that was mosly bent the wrong way around so it broke at one instance. I replaced the 3 largest clearparts with a piece of Trumpeter 1/350 airplane set transparent box cover, that has the right thickness to be able to sand the corner roundings in it. The air purifier system is not installed completely, because that would impede the clearpart masking. So now it's down to interior painting.
15 July, 01:26
gorby
Looks amazing so far!
I'm also amazed at the number of projects you have on the go and still manage to achieve such remarkable results.
Looks amazing so far!
I'm also amazed at the number of projects you have on the go and still manage to achieve such remarkable results.
15 July, 14:03
July 10, 2024
July 9, 2024
Steven Van Dyck
пометил этот товар как заказанный
пометил этот товар как заказанный
WWII USN
USS Massachusetts BB-59 1945 - Complete Upgrade Set for Trumpeter 05306 Five Star Model 1:350
FS350048 2017 9 July, 18:31
July 6, 2024
July 5, 2024
Steven Van Dyck
This was presented as a kit with a type 90 tank, even in that subject, so I changed this to type 10.
This was presented as a kit with a type 90 tank, even in that subject, so I changed this to type 10.
JGSDF Fire Power in Fuji Type 10 MBT, Type 99 155mm SPH, Diorama Base, Tent & Figures
Pit-Road 1:144
SPK02 2024 Модельный набор Несколько моделей (2)5 July, 08:37
June 29, 2024
Steven Van Dyck
добавил новый фотоальбом.
добавил новый фотоальбом.
All comments (64) » 59 11 July 2022, 22:40
Steven Van Dyck
Thanks, SM! The ruins are now painted using Vallejo primers and colors. I use vivid colors and then tone down to get depth. The earth colors will be "grassed".
Thanks, SM! The ruins are now painted using Vallejo primers and colors. I use vivid colors and then tone down to get depth. The earth colors will be "grassed".
29 June, 00:09
June 28, 2024
June 24, 2024
June 22, 2024
Steven Van Dyck
добавил новый фотоальбом.
добавил новый фотоальбом.
All comments (15) » 23 8 April, 00:28
Steven Van Dyck
Thanks, guys. Today you get the Maestro airbrakes. Nice detail, but there is no space for the mechanical parts that make them work. I might cut into the interior parts to add those. I also scratched a part for the jet exhaust that's not in the kit but should have been in the PE set in my opinion, as it is clearly visible from outside. And then I had an idea for the missing rivets that should be on the wings and the canards. Why not add these with the Mastertools Rivet Punch? That was lingering in my toolbox for a year, now it's very useful.
Thanks, guys. Today you get the Maestro airbrakes. Nice detail, but there is no space for the mechanical parts that make them work. I might cut into the interior parts to add those. I also scratched a part for the jet exhaust that's not in the kit but should have been in the PE set in my opinion, as it is clearly visible from outside. And then I had an idea for the missing rivets that should be on the wings and the canards. Why not add these with the Mastertools Rivet Punch? That was lingering in my toolbox for a year, now it's very useful.
19 June, 14:16
Steven Van Dyck
The airbrake locks are now perforated. The tail fin is regraved and the undercarriage is completed as a dry-fit. I saw one camera-glass is partly detached but I can't get into the nose cone without drilling now to push it back.
The airbrake locks are now perforated. The tail fin is regraved and the undercarriage is completed as a dry-fit. I saw one camera-glass is partly detached but I can't get into the nose cone without drilling now to push it back.
22 June, 00:56
June 15, 2024
June 14, 2024
June 12, 2024
Steven Van Dyck
владеет этим предметом
владеет этим предметом
Avenger, Helldiver, Hellcat & Corsair Cockpit Detail Set
White Ensign Models 1:350
PE 35057 12 June, 18:44
June 4, 2024
June 3, 2024
Steven Van Dyck
Today its the 2024 edition, but there has not been made a page for it. This evening I will have an album to show, but it should not be named 2023.
Today its the 2024 edition, but there has not been made a page for it. This evening I will have an album to show, but it should not be named 2023.
KMK Scaleworld 2023
Geel
21. Май 2023
21. Май 2023
1 June, 22:45
Tyrion
I created a page:
KMK Scaleworld 2024 (2. June, Geel BE)
Feel free to add corrections, I'm not one of the organizers.
I created a page:
KMK Scaleworld 2024 (2. June, Geel BE)
Feel free to add corrections, I'm not one of the organizers.
2 June, 16:54
Steven Van Dyck
Thank you Tirion, I added the album now. I see you were there too, with the Gripen!
Thank you Tirion, I added the album now. I see you were there too, with the Gripen!
2 June, 21:19
Tyrion
I did, yes. First time in a competition. I'm quite new to model building, so it was quite the experience!
I did, yes. First time in a competition. I'm quite new to model building, so it was quite the experience!
3 June, 08:10
June 2, 2024
June 1, 2024
Steven Van Dyck
добавил новый фотоальбом.
добавил новый фотоальбом.
All comments (13) » 20 14 May 2021, 22:43
Steven Van Dyck
The raider has undergone some weathering and is now ready for KMK Scaleworld tomorrow. I made a new movie on a turntable: Youtube Video
The raider has undergone some weathering and is now ready for KMK Scaleworld tomorrow. I made a new movie on a turntable: Youtube Video
1 June, 07:32
May 21, 2024
May 18, 2024
May 15, 2024
Steven Van Dyck
завершил
завершил
USAF fighter pilot seated in a/c (WWII)
PJ Production 1:48
481103 15 May, 01:18
wnolder.php?lang=ru
2024-05-15 01:14:33
2014-05-15 21:19:56
15656
/ajax/wnolder.php?lang=ru&sd=2024-05-15 01:14:33&md=2014-05-15 21:19:56&filter=&w=15656
todo