databáza modelovania v mierke | správca skrýše
Warthoglover
J R (Warthoglover)
US

OV-10A Bronco Marines

Album image #1
3D Seatbelts 
 

Album image #2
Rear cockpit 
 

Album image #3
Overhead 
 

Album image #4
Cockpit rear deck with 3D decals 
 

Album image #5
Front cockpit 
 

Album image #6
Fit issues on lower fueselage, My mistake I installed the cockpit interior walls on the wrong side of the floor tab. I sanded them down as much as I could and still had a slight gap. I used Vallejo putty to fill it before priming 
 

Album image #7
The instructions have u adding the main gears with the booms, I dry fitted and determined I could leave them off until after painting  
 

Album image #8
After a prime coat using Mr Surfacer I applied Tamiya black using an AK spatter template. 
 

Album image #9
Lower fueselage was painted with a 50% dilution of AK real color camofluage gray 
 

Album image #10
Masking white areaa 
 

Album image #11
Finish coats and decals 
 

Album image #12
Finish coats and decals 
 

Album image #13
Finish coats , decals and weathering with Flory grime wash 
 

Album image #14
Finish coats , decals and weathering with Flory grime wash 
 

Album image #15
Finished with weapons, MK-81 snake eyes and 7 shot LAU-68 rocket pods.  
 

Album image #16
Finished with weapons, MK-81 snake eyes and 7 shot LAU-68 rocket pods.  
 

Album image #17
Under side detail and cockpit, The 4 piece canopy was difficult to align  
 

Album image #18
Forward fuselage 
 

Album image #19
Underside and ordinance detail  
 

Album image #20
Showing off the white ID panel;s on the wing and stabilizer  
 

Album image #21
Showing off the white ID panels on the wing and stabilizer 
 

Album image #22
Showing off the white ID panels on the wing and stabilizer 
 

Komentáre

31 19 September 2023, 03:35
Łukasz Gliński
Following
23 September 2023, 19:30
Michael Kohl
Nice result. I just started the kit and am amazed by the quality. I am just not able the cram in 5 g of lead into the tiny front compartment. How did you do it?
22 October 2023, 14:06
Mirko Römer
Splendid result! A quick build, too! 🙂
@ Michael: Try placing some weight in the front engine nacelles or the wing. It just has to be in front the main glanding gear. I tried this 15 yers ago with the Revell kit. The ICM one is just smiling fron the stash... 🙂
22 October 2023, 16:36
Guy Rump
Excellent job! 👍
22 October 2023, 18:30
J R
Micheal Mirko is correct I packed the front of the engine cells with pellets of Liquid Gravity. It was just enough to change the balance.. Its a gr8 kit and zi am anxious for the D to be released in 1/72. Thank you both for the kind comments.
27 October 2023, 02:17
J R
Thank you Guy I appreciate it
27 October 2023, 02:18

Album info

See Project

22 snímky
1:72
dokončený
1:72 OV-10А Bronco (ICM 72185)1:72 OV-10A Bronco - interior 3D decals (Kelik K72042)

Všetky albumy

Zobraziť všetky albumy »