Tamiya StugIV, 1/35
1
July 14, 2024Cast surface simulated by good old stippling method. I used Mr. Surfacer 500 for this job. Cast numbers are then glued simply.2
July 14, 2024Behind the scenes you how the cast number was created. Used a flat type scalpel to carve off the sprue numbers. Then these numbers were glued to the casted surface. Kind of easy but entertaining process.3
July 14, 2024Some texturing on the lower glacis crested by dilluted putty. The tow eyelets are kitbashed from Miniart PzIV kit.4
July 14, 2024Again some texture on the rolled steel surfaces. The commander cupola is from Miniart BzBeowg IV.5
July 14, 2024Here the starboard side.6
July 14, 2024Ah, and here comes the zimmerit. Used my Tamiya zimmerit maker and a water based putty. My first ever zimmerit, at the age of 44. Lost my virginity 🙂7
July 14, 2024Exhaust muffler found to be short. Added a few mm of epoxy putty.8
July 14, 2024After some primer looks a bit worn and dent, but okay for me.9
July 14, 2024MG shield after some upgrades. Used PS sheet and stretched sprue. Yes, that ugly ejector pin mark is filled with putty.10
July 14, 2024Zimmerit everywhere. The rolled steel texture is gone. Mention here the old Eduard PE fenders I found in my stash. Front plate rivets are scraped off from another ancient kit part I found. Think it was from a StugIII kit.
Komentáre
1 14 July, 22:29