Qatar Emiri Air Force Mirage 2000-5 Project
Komentáre
15 November 2013, 14:19
![](/profiles/img/11761-776-s.jpg)
I opened the Eduard PE set and noticed that the lower half of the central fret (see picture 4) is not listed nor shown on the instruction sheet. The large rectangle is grooved and the supports on the left make it appear to be some kind of weapons trailer? I'm at a loss. Any help would be appreciated.
15 November 2013, 15:16
![](/profiles/img/13058-452-s.jpg)
I'm not sure but are you talking about the part you roll around the inside of the engine nozzle?
15 November 2013, 18:26
![](/profiles/img/13058-452-s.jpg)
Page 3 of the instructions shows the part I think you're talking about.
eduard.com/store/out/media/48386.pdf
15 November 2013, 18:30
![](/profiles/img/11761-776-s.jpg)
@ SHADOWFLASH: Ah so deska! Yes I see now! And the tabs to the left are to make a ring fo rthe insdie of the exhaust nozzle. I've got it now. I was stumped for a minute. Thank you! R/ Dutch
15 November 2013, 20:26
![](/profiles/img/11761-776-s.jpg)
What is typical AAM load for QEAF Mirage 2000-5EDA? From picture 3 it appears as 2x Magic & 4x MICA (either IR or RF)? Monogram kit comes with 2x Magic & 2x Exocet, but no Matra Super 530 or MICA. Does anyone want to swap 2x Super 530 or 4x MICA for my 2x Exocet?
15 November 2013, 20:55