DONE ! ....Pilatus PC-6 Triple Build

1
December 27, 2019
2
December 27, 2019
3
December 27, 2019
4
December 27, 2019
5
December 27, 2019
6
December 27, 2019
The application of "Fred's" decals went good,....
7
January 1, 2020
...the decals film is of good quality and transfer from paper to model went good.
8
January 1, 2020
Dispite to Fredi I had my challenges with Elise's paint scheme,....
9
January 1, 2020
...The film was pretty old and during application it broke apart in "1000" pieces. Finaly the flash in the back is a kind of flash (20+ segments) but applied too far at the rear. Bad luck.
10
January 1, 2020
The straight military paint scheme went easy and was necessary to calm down after the screwed Blue Elise. 🙂
11
January 1, 2020
12
January 3, 2020
A pic of the sprue - as you can see: short run quality of course 🙂 that's why we love modelling, right?
13
January 3, 2020
original tyres vs resin tyres from IPMS Austria conversion kit
14
January 3, 2020
changed to PE antenna parts as well
15
January 3, 2020
also propeller and spinner from resin conversion kit
16
January 3, 2020
my 3 NEW prop's
17
January 3, 2020
PE action....
18
January 3, 2020
the cabin air vent exhausts
19
January 3, 2020
drilled a hole on my antenna socket
20
January 3, 2020
dry fit of antenna & socket
21
January 3, 2020
spare cabin windows,.... vacu-formed
22
January 3, 2020
bottom fully equiped (PE's on,...yes, tyres still missing)
23
January 8, 2020
Also bottom side of Blue Elise quite finished now,... pilots door steps not on yet.
24
January 11, 2020
A view on Fredis bottom....
25
January 17, 2020
26
January 17, 2020
27
January 17, 2020
28
January 17, 2020
29
January 17, 2020
30
January 17, 2020
31
January 17, 2020
32
January 17, 2020

Komentáre

1 27 December 2019, 17:48

Łukasz Gliński
Following! I think I wrote it on the project page too 🙂

27 December 2019, 18:57

Juergen Klinglhuber
Lukasz, 🙂 thx for your interest.
I will put together the progress on painting/decal and photo-etched parts. Unfortunattly I have made less pic's during the challenging assembly. ....

30 December 2019, 10:13

Juergen Klinglhuber
All decals are on! I had my troubles with Blue Fred. The film was already old when the kit went on my stash 10 years ago. A surfacer prior to giving the sheets in the water bath did help a lot, but still the scheme broke in pieces during transfer. I was close to run for the airbrush to apply the flash on the rear section with paint instead of decals. ...

1 January 2020, 09:48

Łukasz Gliński
That green looks great, what colour is it?

1 January 2020, 14:58

Stefan Fraundorfer
I'm in Jürgen. I love the "bunte Fredi". Have fund and good luck!

1 January 2020, 15:19

Thomas Bischoff
I love your porters - the interior in picture 11 looks great!

1 January 2020, 15:27

Juergen Klinglhuber
Thx mates.
@Lukasz: the base is Humbrol 150 forest green, some panels altered with Humbrol 102 army green blurred in. Preshading with black (lines) and yellow (panel center).

2 January 2020, 07:36

Łukasz Gliński
Thx for the info Juergen 👍

2 January 2020, 08:20

Erik De Smet
Same advice as for Donald :. Scan your special decals before using them, so that you can print a replacement if you have trouble.

2 January 2020, 12:13

Juergen Klinglhuber
Thx Erik -I will give it a try next time. I hope my scanner is doing an acurate and detailed enough job.

2 January 2020, 15:19

Treehugger
Btw, Roden has this (Pilatus Turbo Porter) kit in 1:48 scale, and they are ok, but some fiddling is required. I've built two of those from Roden.

3 January 2020, 13:41

Juergen Klinglhuber
Bottom side of "Blue Elise" - done. "Fred" is still waiting,.... looking forward to attached the last details (antennas, exhausts,...) on the upper side of my 3 birds to finally finish this project.

8 January 2020, 21:37

Juergen Klinglhuber
Fred's bottom. Finish line is getting closer... 🙂

11 January 2020, 12:50

bughunter
Oh, den "Bunten Fredi" mag ich😉 Sehr schön 👍

11 January 2020, 13:33

Łukasz Gliński
Your Fredi looks grand 👍

11 January 2020, 21:48

Juergen Klinglhuber
Ready for Take off! PC6 triple build done. Was fun.
I added a few snapshots.

17 January 2020, 18:08

Thomas Bischoff
a great looking trio!

17 January 2020, 18:17

Dave Flitton
I love the result, nice set of three

17 January 2020, 18:26

Gordon Sørensen
Great looking Porters, Juergen! I especially like Der Bunte Fredi!

17 January 2020, 22:46

Łukasz Gliński
Wow, they look stunning! Now everyone wanting to build another PC-6 will have a problem deciding which livery to choose (like me) 😄

18 January 2020, 10:28

Stefan Fraundorfer
A very spectacular trio. Great work Jürgen!

18 January 2020, 12:48

Juergen Klinglhuber
@All - thx for your motivating comments. It seems that Der Bunte Fredi is our favourit.

18 January 2020, 16:26

Album info

Building 3 PC6 Turbo Porter operated by Austrian Airforces in one go.
a) 1x in a regular paint scheme
b) Blaue Elise: Celebrating 20 years of operation with the 4th squadron in 1996, 3G-EK was painted in a special livery as "Blue Elise"
c) Der bunte Fredi: Since July 2007 3G-EL is showing the special painting "the colourful Fred"

#P16 Pilatus PC-6 Turbo Porter

41 snímky

1:72

dokončený

1:72 Pilatus PC-6 (Wien Alaska Airline & Paracentrum Texel) (Classic Plane CPI 05)

1:72 Pilatus PC-6 "Turbo Porter" (Classic Plane CPI 04)

1:72 Resin Prop for Pilatus PC-6 (IPMS Austria 02 020)

Všetky albumy

Zobraziť všetky albumy »