2003 Dodge Viper SRT-10
![](/albums/img/5/5/1/1042551-32137-28-p.jpg "Step 1-3 from the Instructions
1. I laid out the parts required and inspected the parts for defects or cleaning required;
2. There are no narrative on the instructions and at best some of the locations are vague.
3. The reflective material to the wing/side mirror and rearview mirror were attached using the tip of a scalpel and brandished down using a earbud.
4. Follow the numbers in order in each of the illustrations. "Einstein" here installed the door panels before the wing/door mirrors and had to remove the door panels again. First the wing/door mirrors, then the door panels. The door panels secure the mirrors in place. | View full picture")
![](/albums/img/5/8/6/1042586-32137-60-p.jpg "Step 4-6 from the Instructions
1. I laid out the parts required and inspected the parts for defects or cleaning required;
2. Double check before you insert the roll bars. Both must incline forward and the longer part of the "leg" must be on the outside;
3. Insert the seatbelts from the bottom (floor pan) up and secure using the appropriate stub as anchor. | View full picture")
Komentáre
Disabled
Album info
A Die Cast Model Kit, friction fit, build out of the box
databáza modelovania v mierke | správca skrýšedatabáza modelovania v mierke | správca skrýše
A Die Cast Model Kit, friction fit, build out of the box
