Austrian Sikorsky S-70 - EUFOR - DONE

1
November 7, 2022
2
October 31, 2021
Finally....everything collected what was in my mind....ready for a start.
3
November 1, 2021
Release the first parts from the sprue,.....
4
November 1, 2021
This EUFOR version will also have all doors closed - so I'm lucky, because the Hasegawa interior of this kit is lackinig details. I nevertheless I'm thinking of some improvements,....
5
August 10, 2022
Here we go,...some improvements of the cockpit section that....
6
August 10, 2022
...could be seen from the outside.
7
November 7, 2022
Some steps forward with the interior.
8
November 7, 2022
Some details to the cabin added.
9
November 7, 2022
Tryfit....
10
November 7, 2022
11
November 7, 2022
The Hasegawa kit doesn't have protruding panel lines, which is nice, but some lines are missing.
12
December 9, 2022
Same now on the front side - intakes are covered...
13
December 9, 2022
So here we take a look at the exhaust(s). Left hand the current Hasegawa kit (UH60A) and on the right side the Revell kit (UH60A). Well, both looking not quite right.
14
December 9, 2022
Here on the left hand I have added the resin exhaust from Armycast. Looks much better,....but a lot of "carving" is needed to fit the resin part onto the fuselage and....
15
December 9, 2022
....to open it up.
16
December 9, 2022
...as you can see here - the part shows the exhaust closed. So a milling session was needed.....
17
December 9, 2022
The exhaust manifold that is visilble on my birds are modelled with "old" and therefore malleable "Dissolved Putty" from Mr. Hobby.
18
December 9, 2022
Giving it a try - looks quite ok.
19
December 9, 2022
Manifold on. Exhaust cover on. Intake on. - all dry until now - to see if further adjustments are needed.
20
December 9, 2022
A view of the left side. Meanwhile I have also glued on the side/forward infra-red device underneath the cockpit doors.
21
May 7, 2023
Also on the tail we need....
22
May 7, 2023
...to have sensors.
23
May 7, 2023
All exterior and interior work is finished now - so the 2 fuselage parts can be joined.
24
May 7, 2023
All masks on.
25
May 7, 2023
For motivation purpose I "blue-tacked" fuel tank & external load beam on the chopper. Looking okay.
The tank is not from the Hasegawa kit as this one would not represent the tanks used by the Austrian Blackhawks - it's a spare part from a Revell box that fits (with a tiny mod) much better.
26
May 7, 2023
A first coat of black primer unvealed some imperfections on the joints and surface.
27
May 7, 2023
The Helicopter after the rework and with a 2nd shot of Ultimate selfleveling primer.
28
May 7, 2023
I did not mention before that I added radar sensores not only on the tail. One pair of the forward looking sensors is from ArmyCast - the 2 others (missile and laser warning system) are "home-made". The Radome was purchased from BrentAir Decals.
29
May 18, 2023
I was made aware by a mate that I missed to build in radar warning receiver APR-39 also at the tail. So some further tiny scratch work is needed here.
30
May 19, 2023
31
May 19, 2023
32
May 18, 2023
A bit of scratching also...
33
May 18, 2023
...here on the tail boom. Ready to go in the paint box again
34
September 19, 2023
...finished mottling.
35
September 19, 2023
top coat and gloss applied
36
September 19, 2023
started to add decals
37
October 18, 2023
same issue as with the KFOR version - I missed a canal or hole into the cockpit. So after de-masking the window panes I had to face quite an amount of sanding debris and tiny junks of styrene. So - same procedure: open the window and let in some fresh air 🙂
38
October 18, 2023
Detailsing goes on,...all in place in the downward area,...e.g. details for attaching the aux. fuel tanks
39
October 18, 2023
almost done - pits & pieces to be added - plus: waiting for rotors
40
February 11, 2024
41
February 11, 2024
42
February 11, 2024
43
February 11, 2024
44
December 1, 2023
45
December 1, 2023
46
December 1, 2023
47
December 1, 2023
48
December 1, 2023
49
December 1, 2023
50
December 1, 2023
51
December 1, 2023
52
December 1, 2023
53
December 1, 2023

Komentáre

82 5 October 2021, 20:09

Oleg Bogolei
Very interesting project. Following.

2 November 2021, 08:03

Tino Delgado
Two rotor Birds?? WOW, great to see! Keep up the good job!

2 November 2021, 15:03

Juergen Klinglhuber
🙂

2 November 2021, 20:56

Ronan
I'm in 😉

2 November 2021, 21:40

Harry Eder
Me too!

3 November 2021, 06:02

Juergen Klinglhuber
Summertime always slow down build progress. In addition to that I kind of burned the candle from both ends on this quadruple blackhawk build...but it seems that finally I have sorted out the issues and the builds continue.

10 August 2022, 10:12

Laurent VILLANUEVA HELLER ForEver
Nice !

7 November 2022, 13:42

Finn
Nice, will follow

7 November 2022, 18:38

Juergen Klinglhuber
Thx Laurent & Finn.
Nice to have you on board Finn. I'd like to invite you to follow up on my 3 other Blackhawk builds too (I am doing my privat quadruple groupbuild here 🙂 ). Things going slow, but forward..... 😉

7 November 2022, 21:55

Martin Grafeneder
Da schaut man gerne zu👍

8 November 2022, 09:06

Juergen Klinglhuber
Freut mich - take a seat!

9 November 2022, 21:22

Juergen Klinglhuber
Hello everyone - new status & pic's available.

9 December 2022, 22:44

Ronan
Nice progress, Juergen 👍

10 December 2022, 06:35

Juergen Klinglhuber
Thank you Ronan. Your comment is motivating. Doing 4x the same model (with only small variations) at the same time is more exhausting than I did expect. 🙂

11 December 2022, 10:01

Bernd Grün
Nice progress, Jürgen. Following with interest.! 👍

14 December 2022, 14:54

Juergen Klinglhuber
Thx Bernd. Nice to have you aboard.

14 December 2022, 19:30

Juergen Klinglhuber
As you might have recognized I had a little progress on this one. I just figured out, that maybe I was a bit too motivated to get this chopper primed - did not consider attachment of all the externals (antennas, pitot,..). So some adjustments are needed before continuing with the painting.

10 May 2023, 09:56

Ekki
Watching.

10 May 2023, 18:15

Guy Rump
Following. 👍

10 May 2023, 19:14

Juergen Klinglhuber
Welcome Ekki & Guy Rump.
I have to let you know that some patience is needed here as these 4x S70's I have started are only progressing at a low pace. 🙂

12 May 2023, 13:52

Juergen Klinglhuber
update - paint is applied,..started to do the decals...

19 September 2023, 11:11

Laurent VILLANUEVA HELLER ForEver
das gut !

19 September 2023, 17:44

Juergen Klinglhuber
Merci pour votre commentaire.

20 September 2023, 17:59

Juergen Klinglhuber
up-date

18 October 2023, 17:32

Juergen Klinglhuber
So - after a while here are the first set of final photos on my 4xbuild of Sikorsky S-70. The EUFOR version with aux. fuel tanks.
Thx you Roland for your time and patience & giving me some advice during the photoshooting. I hope to solve the technical issue with my equipment soon in order to follow up with pic's from the other choppers soon.

1 December 2023, 19:38

Ronan
Very nice 👍

3 December 2023, 09:01

Neuling
Yes!

3 December 2023, 10:50

Guy Rump
Very nice build! 👍

3 December 2023, 10:51

Martin Grafeneder
Great Work!!!

3 December 2023, 15:39

Juergen Klinglhuber
Thank you Ronan, Neuling, Guy & Matl.
Your feedback is balm on the modeler soul - especally on this Blackhawk build(s). It was quite a journey to get to the end. 👍 thx

5 December 2023, 07:27

Bas Tonn
Nice work !! Nice background too 😉

5 December 2023, 07:30

Juergen Klinglhuber
Thx you Bas Tonn!

9 December 2023, 09:30

Ekki
Excellent work!

4 January, 19:57

Juergen Klinglhuber
Thx Ekki for the comment and to all others for your "likes".

6 January, 14:33

Stefan Fraundorfer
A very nice Austrian Black Hawk Jürgen. Congratulations!

6 January, 16:12

Juergen Klinglhuber
Thank you for leaving a comment Stefan. Happy to hear you like it.

10 January, 18:57

Bernd Grün
Very nice build and presentation, Jürgen! 👌 Congratulation.

11 January, 09:41

Juergen Klinglhuber
Thx Bernd. As my equipment is on "sick leave" this pics are made in cooperation with Roland (thx btw).

16 January, 06:33

Łukasz Gliński
Very nice finish and not often you see unusually marked BlackHawk 👍 My only complaint would be the cockpit door windows being bit dirty

16 January, 11:24

Juergen Klinglhuber
Thanks Lukasz.
And unfortunattly you are right, it loooks quite bad - it was a sad experience to find out after demasking that I have somewhere overseen a path where sanding debris could enter the cabin. The rescue operation at the end by removing a glass was only partially a success. 🙁

17 January, 08:15

Juergen Klinglhuber
Thx all for further incoming likes!

26 March, 10:14