Најважније вести
Filip
жели овај предмет
жели овај предмет
Vickers E Mk A Czołg lekki dwuwieżowy [Light Tank Twin Turret]
Mirage Hobby 1:35
35303 200x Нови делови 16 August, 13:26
Dmwilde
жели овај предмет
жели овај предмет
Kawanishi H8K2 Type 2 Flying Boat Model 12 '901st Flying Group'
Hasegawa 1:72
02473 2024 Нови декали/налепнице 16 August, 13:17
Bill C
will attend
will attend
Modelpalooza Saskatchewan 2024
18-20 Октобар 2024
18-20 Октобар 2024
15 August, 20:38
Ken Kolenovsky
Not sure where this listing came in Bill, but it is not the one I put on Scalemates. This one is listed under "Group Builds" and that isn't what I set it up as. I also see that there is a link to our Facebook site, but I didn't enter that. Curious.
Not sure where this listing came in Bill, but it is not the one I put on Scalemates. This one is listed under "Group Builds" and that isn't what I set it up as. I also see that there is a link to our Facebook site, but I didn't enter that. Curious.
16 August, 13:16
Alex Rakhimgulov
додао је нови фотоалбум.
додао је нови фотоалбум.
23 27 June, 09:04
Villiers de Vos
Very nice texturing and weld marks on this Soviet beast. The photo etch details is a nice touch.
Very nice texturing and weld marks on this Soviet beast. The photo etch details is a nice touch.
10 July, 02:10
Alex Rakhimgulov
Thank you, Mate! This photo etch is selfmade from 0.2mm brass plate ))) I need to buy the photo etch bender, to make it better. ))
Thank you, Mate! This photo etch is selfmade from 0.2mm brass plate ))) I need to buy the photo etch bender, to make it better. ))
10 July, 07:14
Alex Rakhimgulov
Thanks, Mate!
I try to make weld beads like on my favorite YT cannel )))
1) I make a groove with scraiber, if it necessary on the plane surfaces.
2) Next, i prepare 2 component putty, and make a thin "laces" out of it.
3) After that, I carefully fill the grooves and angles with putty "laces" and apply welding texture with special tool (toothpick with tip warped with brass sheet, witch forms small speared C shape).
That is all.
Thanks, Mate!
I try to make weld beads like on my favorite YT cannel )))
1) I make a groove with scraiber, if it necessary on the plane surfaces.
2) Next, i prepare 2 component putty, and make a thin "laces" out of it.
3) After that, I carefully fill the grooves and angles with putty "laces" and apply welding texture with special tool (toothpick with tip warped with brass sheet, witch forms small speared C shape).
That is all.
9 August, 09:30
/sr/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
search-solr.php?lang=sr
35
35
/sr/search.php?q=*&page=newsfeed&fkSECTION[]=Newsfeed
35
todo